Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: jwbj
  • Order by date
  1. jwbj

    VPN site-to-site with Nortel gears ?

    Curtismo, We are exploring the option of moving a number of BO tunnels from a Contivity over to our 3050 deployment and would appreciate it if you could expand a bit on your "varying issues with tunnels dropping, etc." post.
  2. jwbj

    3002 hardware client behind a DSL router

    Burt, The question has been answered at this point but thanks for your input.
  3. jwbj

    3002 hardware client behind a DSL router

    Burt, Actually, the confusion comes in because the DSL router has two paths into the backend network. One is the 3002 the other is the Linksys. Due to the fact that the far end concentrator has the public IP of the DSL router as its peer any connections initiated from the far end office would...
  4. jwbj

    3002 hardware client behind a DSL router

    This one has me scratching my head a bit. Keep in mind I have not laid my hands on any of the gear described here nor have I even been to the site in question. Here is the scenario... A dsl router with one public port/IP facing the Internet and two ports on an RFC 1918 subnet A Cisco 3002...
  5. jwbj

    2430 interface statistics

    I am looking for a way to reset the interface statistics on a 2430 router while at the CLI or in the BCC.
  6. jwbj

    Error errno 0x380700 Passport 8006

    We ran into a similar problem. Use the 'copy' command instead of the 'cp' command. Also, this may be obvious but ensure your tftp server is running and accepting connections.
  7. jwbj

    Frame Relay w/ Contivity 1100

    Has anyone successfully set up a Contivity w/ T1 CSU module as a frame relay router? We can get RIP traffic to traverse the circuit but data traffic will not pass and the log shows no indication of a problem. 1. SW V6.00.310 2. Firewall enabled w/ any any any allow rule 3. LMI set properly as...

Part and Inventory Search

Back
Top