Search results for query: *

Yeh I didn't notice any authentication. That is something I looked for. I unfortanetly didn't get much into each interfaces config which was a mistake on my part. Thanks for the help. Jordan

The networks are all connected via serial connections so they would be nonbroadcast to nonbroadcast. Do i have to set that in the configuration somewhere? Hello/holdtime timers i never thought about but that could have been the problem. Routers A and B were already configured for me and were set...

Its all from memory. If you know something specific I might be able to recall it. The ip addresses arent exactly the same but its the same idea and what not.

How do I go about the neighbor state? I've been reading about it but i'm more of a hands on person and unfortanetly can't get ahold of my instructor.

Well since router C was added later can it still be put into area 0 or would it need to be say area 1 or something else?

Yeh my mistake thats what i meant. I'm doing this from memory from a simulation test.

no the ethernets stub off into their own networks. the routers are only attached via serial interfaces.

My mistake that is enabled just forgot to add it to the original post.

Hi, I have a question about ospf i'm having trouble understanding some of these concepts. Say you have 2 routers Router A int s0 ip address 192.168.1.1 int E0 ip address 172.16.1.1 router ospf 1 network 192.168.1.0 area 0 network 172.16.1.0 area 0 router B int s0 ip address 192.168.1.2...