Search results for query: *

First option. The reseller has no networking specialist in their pool. Also, the technicians do not know the product well at all. I'm actually more knowledgeable on the system... however I am not an expert. So... The rundown. Solutions welcome. * 3 locations * Connected via megalink T1...

Basically, they said that it had to be bridged or that it could be routed. They said we should bridge it. I asked about Nortel's gateway because since I read about it on their website and asked if it was an option. Apparently... they didn't know much about it.

What routing protocol are you using?

I believe it's the BCM 400 unit.

When you say you program the i2004 phones via the IP client. Explain this... Are you talking about the web interface or are you talking about another application I may not be familiar with? Do you use static addressing for the phones or DHCP? I appreciate all this advice on the system. I'm...

Nothing at the moment due to this issue right now. Before, I was using EIGRP. Do you know if the BCMs have Rip v1 or v2? If I used Rip... I'd prefer to use MD5 hashes from the source to add protection. I doubt the BCM has this option "not at work or I'd check". I'm starting to feel our vendor...

We're using megalink point-to-point T1 circuits running on HDLC. Unfortunately, they must be in the same subnet as the BCM - this is per the vendor (however we may be misinformed). I'm open to any suggestions of other methods that are logical.

Yes, that is correct. Route data, bridge voice over a single T1 link to each facility using Cisco 1800 series routers.

The traffic has to be bridged because we are about to have two sites on different subnets. The BCM will not handle routing without two more devices at the other facilities for a pricey nominal figure. So the cheaper and more logical method to save money and not waste assets would be to bridge...

Yes, we have a Nortel BCM at our main facility that handles VoIP. Instead of spending $20G a facility, we'd like to bridge the VoIP and route the other data.

Hey all, I need some assistance on bridging / routing on the same router. I've got a single port for VoIP that must be bridged and another single port for Data that must be routed. These both will be going over serial T1 links to two seperate facilities. Any tips or sample code would be...