Search results for query: *

Greetings - SV9100 CP20 for the 2nd time the SD card will not allow to upload any files as reporting its full. I have deleted the SMDR buffer and rebooted but this did not resolve the issue. I previously went to site, removed the card copied the contents reinitialised and reinstated the backup...

Quick question, can a NT55x IP Handset use wireless XDP to a SIP extension using the *48 feature code? Idea is to install an algo strobe and when the NT phone rings, the algo will flash.

Hey I've been working on a 1232 with a pri 30 module via some dodgy HDSL equipment belonging to Virgin. I get a dialtone but the digits don't send,. So dial 9 get dial tone dial 012345678901 still solid dialtone. Carrier said it was a system fault but without a harrier I'm not sure how to...

Howdy Currently taking over a site with a sl1100 which will be eventually upgraded to hosted. They have a door intercom that I have never seen before, anyone come across one or even know where I can find a...

Sure i've done this before but cant remember how, I am wanting to change a greeting for a mailbox remotely. I've enabled remote log on the the PS which works using *47 ext pin but as soon as I dial *381 I get the reorder tone. Remote access is enabled for the SVM, anything else I need to do?

So I have a NS700 with the fancy Panasonic Softphone. This is registered and can and make receive calls. I have the softphone wireless xdp to the deskphone. Problem I have is if an interal call is made to the desk phone there is a good 8-10secs delay before the mobile rings and if the call is...

Greetings, Been asked to setup an ICD on a NS700 that will ring the internal extensions and a mobile. From memory i think this is a licensed feature as using virtual PS does not work. Is my theory correct or is there any other way?

Pulling my hair out over this. Have a sl2100 with 2 door boxes, front had a door strike and rear has a maglock Each are wired to separate esp 12v psu.the relay from the sl2100 wires directly to the push (to exit) button on tge esp psu. Door 1 is programmed with relay 1 and door 2 with relay...

Howdy Is it possible for a mobile extension to change the time mode if they dial in? I'm trying to setup a mobile extension using callback but cannot get this working (using SIP trunks) and unable to dial anything once I dial the test trunk and presented with dial tone.

Howdy Having a mere with remote conference, i've deduced a licence issue but unsure which licence is required can anyone advise whats missing. I tried setting the PASSWORD mode to SKIP but still get busy on ringing the...

Hello, Strange issue, I have a barrier working on a mobile sim that rings an analogue trunk. When answered pressing 3 should open the barrier, but this is not happening. It worked up until the point the firmware was upgraded from v2 to v7.13. I've swapped the hardware but will not work for...

In the manual it stipulates that 2 traditional cell stations can be installed max. Can they both go on the dlc2 card or does one require an expansion card and or licence? I recall back in the day that cell stations had to be 3 pairs away on the mdf. Just installed an ns700 with 2ipcs and 2...

Hi everyone. Came across these handsets today and once I got over the gigantic display I was so far unimpressed. Anyway the issue I have is that the display is all grainy and sometimes it will just go blank, phone will still work but obviously unbeknown what I'm pressing. Anyone come across...