Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations dencom on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: nzgordini
  • Content: Threads
  • Order by date
  1. nzgordini

    7100 Combo Card Going Dead

    Hi Guys, I have a 7100 (V4.82) with MP10a in slot 0, Combo2 in slot 1 and a UNI card (with 2 x 4DLM + 1 x 2BRM installed). The combo card slot is going dead every couple of days. It is resolved for about 2-3 days by a power restart. I initially replaced the Combo2 with a Combo3 but still have...
  2. nzgordini

    Adding Additional IP Office Sites To Existing UCM One-X Portal

    Hi Guys, I have two IP Office systems (both 10.0.0.2.0(10)) connected via SCN. I have recently installed a UC Module into one site and have siccessfully integrated this into the local system (both One-X and Voicemail Pro). What additional steps are required to enable One-X and Voicemail Pro...
  3. nzgordini

    IP Office 500V2 R10 UCM Voicemail Pro No Go

    Hi Guys - I have recently upgraded one of our IPO 500V2 to R10.0.0.2.0(10). This all went well and has been running quite happily for a couple of weeks. I then installed a new UC Module(V2)with exactly the same version of software and it all appeared to go well with no errors during the install...
  4. nzgordini

    IP Office SCN Problems

    Hi Guys, I have an existing full mesh SCN network of 5 systems (mixture of 9 and 8.1) running over MPLS. Two sites have been recently added and appeared to work for about a week. Now we have a problem where the first call to a particular site is successful, but if I hang up and immediately try...
  5. nzgordini

    How To Transfer Configuration From Old Hardware To New

    I have an old Avaya small office (Rel 3.1-29,IP401 NG) which is slowly dying. A couple of the POT ports are dead and also one of the analogue trunk ports will not trip incoming calls. I have another spare in our store with the same hardware but running rel 7.0-5, IPV500V2 What do I need to do to...
  6. nzgordini

    Avaya IP Office with Patton ATA not able to transfer

    Hi guys this is my first post so be gentle....... I have a couple of our IP Office systems (Ver 6 and 9) to which I have successfully connected Patton ATA sip devices. On these adapters I have both analogue desk phones and DECT cordless phones connected. Incoming and outgoing calls work...

Part and Inventory Search

Back
Top