Search results for query: *

I need assistance on setting up least cost routing on an Ipecs Cloud. I have installed the Trunk Gateway (LGCM4) and also the TDM Channel license. I can receive calls via the Gateway but do not know how to access the gateway for outgoing calls. Any assistance would be appreciated

After setting up offnet fwd via a speed dial, I require the original callers number to be displayed on the received mobile phone, I am using SIP Trunks. Has anyone had experience with this before. Your assistance would be appreciated

Trying to install/ activate the external MOH on main MSU. Does not seem to work. Connected external device to pin 1+2 (Orange-Orange/white) Please Help!! Works ok on an emg 80

Hi, Does anyone know how to setup Scenario Ring Modes on an Ipecs UCP. The manual is very basic

Hi, My customer has created passwords for all the 9x conference rooms and has misplaced it. Is there anyway the Conference Room passwords can be removed, so that everything is back to its default state

How many Ip extensions can an emg80 support. Do I require a system license for Ip phones

Hi Everyone, Has anyone expreienced a problem with a MFIM 1200 where the IP phones/digital phones experience slow responce rate/just hangs when the pabx is flooded with incoming calls. I tried using a MFIM 600 and it does not have the same problem.

Can anyone assist with info on how to setup 2x Ipecs with SIP connection. If anyone has documentation please let me know. Thank you in advance

Hi, Can anyone please advise. What port does VOIP run at? > For example SMTP runs on 25, FTP runs on 21. > Is there a particular port that VOIP runs on.

Does anyone have any idea what is required to interface an Opera Hotel System with an Ipecs LIK.

Can someone please help, I have switched on TNET at the LM for all modules and IP Phones pgm 132. Q1: Do I now also switch on TNET for the same modules and Ip Phones at the CM (pgm 132), Q2: do I also activate TNET on the CM Modules?

When wiring a basic iPECS-SBG-1000 to a LAN network I connect a network cable from any of the Yellow LAN Ports to the customers switch. When I need to use the WAN connection for VPN should I now move the cable from the LAN port to the WAN connection? Can I not bridge the WAN to the LAN and then...

Can anyone please confirm whether CAT5 and CAT6 cable can be glued using a hot glue gun. If not, why not, and what should be done?

Can an extn mailbox greeting be saved to a pc? How is it done?

Hi, I have an Ipecs 100 WITH PRI lines. Recently there is an error message displayed on the terminals, ''ISDN Line Released , no circuit available'' when dialing certain numbers. Does anyone have any knowledge what causes this?

I have setup TNET between MFIM 600 (CM), LM's are MFIM50,100 x2. Everything works but the LM systems keep resetting. Could anyone please provide me with the setup of this kind of network. I would like to check if I have made any mistakes.

After activating TNET the LM sites resEt at times. The LM MFIM's kicks in when this happens. Any ideas why? The CM is a 600 MFIM the LM's are 2x 100's and 1x50 MFIM

After activating TNET the LM sites rest at times. The MFIM kicks in when this happens. Any ideas why? The CM is a 600 MFIM the rest are 2x 100's and 1x50 MFIM.