Search results for query: *

For some reason when I go through this vector the CallerID will not pass to a 9608 Phone. I have the incoming call routed to VDN 8761 which points to vector 61. If I point the incoming number directly to extn 5490 the Caller ID shows up. When I point the incoming number directly to the VDN 8761...

Putting in new cm. Release 7. Virtual servers. Installed avaya onex attendant. Set up 302 console. Set it as extension 7001. Sent it up as telecommunicator mode. Set "0" in dail plan as ATTN. For some reason when you dial 0 you can hear ringback tone and in the list trace it shows ATTN...

Does anyone have any access to any white papers that show examples of how to hook up SIP trunks to an Avaya SBC using the Branch Session Manager? Anything would be appreciated. Thanks,

Upgrading from CM 5.2.1 and have to put patch 02.1.016.4-20790.tar.gz on the system. Does anyone know if this is service affecting? I would also like to leave the patch on for about a week before the upgrade. Does anyone know if that would cause any problems with the 5.2.1? I wanted to get...

Is anyone having trouble using ip office Web manager on release 9.0.3. It works on 9.0.1 but can't get the page to load for release 9.0.3. This is not Server edition. I have tried on 2 different systems and same problem. Thanks

I have a working system that has 8 ip dect phones attached to an IPBS2 Master module. The model phones are 3720. The problem I am having is that I can't get more than 6 of the phones to ring at a time but I have all 8 in a coverage answer group. The isdn trunk group that works between the Master...

I am installing BCMR on an s8300 release 6.0 CM and I dont have a clan board. Im trying to install BCMR release 2.4.7 on a windows 7 64 bit machine. I finally found the right sentinal driver for the usb dongle and was able to get the server software to respond. But for some reason the username...

I can do everything but receive incoming calls. Set up trunk group as ISDN Tie and also tried call by call. I can see my precedence code on incoming trace and I can see 2 extra digits. I have my precedence code set up as 95 and on my trace i see incoming digits as follows 9544 and then the...

I have a g430 with an s8300D at site A. System platform release 6.0.3 and cm version 6.0.1.510. AT site B I have an identical set up that hasnt been installed yet. My question is this. Can I take the translations out of site A and load them into site B and then somehow change the serial...