Search results for query: *

is it possible to voice recording of calls in option 11 c ? if yes please guide me how it can be

I want to introduce the caller tune on meradian option 11 c is this option is available or not ? if available how can it be configured

I want to limit the number of Rings on any extension normally it rings too many times I want to call ring 6 to 8 times and if not attended it automatically disconnect

How to observe the call i want to observe the complete route of PRI Call

when i state the PRI Card dch the error message bug 509 appears anybody please guide me how to remove this bug

I have two PRI Cards One DCH 10 and other DCH 11 clock on card one i.e card number 5 is active but clock on card number 6 dch 11 is disabled please any body can guide me how to enable the clock

my PABX Nortel CS 1000 is with Cust 0 is working now I want to build a mini pabx with in it with CUST 1 is there any document to guide me from scratch to establish new PABX and I also want to terminate one PRI on it

I have Nortel CS 1000 but have some problem when I block DID on maximum extensions the problem is the incoming calls are going to different extensions please guide to solve it

I neet power supply module drawing number NTAK 04 AB or NTDK 70 bb but my supplier told that this will not work with nortel pabx CS 1000 my PABX is nortel meridian pbx option 11c but supplier told that you should purchase NTDU65AA please guide me thanks

Dear ALL I am using Panasonic Telephone set Model No KX-TSC11MX on CLI of set the last digit of incoming call not displayed. and specially when mobile call e.g the number 03155057856 will only display 0315505785 please give me a solution I am using it with NORTEL PABX CS 1000

I am using NORTEL CS 1000 and programming is carried out by procom plus it always shows the messages how can I stop these messages messages are like DTA 300 DTA 301 DTA 302 .. ... ..

I want to take Trunk incoming call on console set only and not on all extension, and also want to pick up call when ringing at console from any extension but bell is not required on extensions please help me I am using Panasonic TES 824

we have purchased the callpoilet and have also the hardware key but the vendor did not activated it and is not working is there anybody who could guide me from very beginning to use this please ?

I am Using Nortel CS 1000 I subscriber demanded to stop the facility of call forwarding, I have tried my best but I reach on result that this can be stopped for the whole system. or only for external calls . but not for a specific extension for local calls. please help me how to disable the...