Search results for query: *

We've seen environmental sensors attached to gateways in the past, as well as the ups being connected to the gateway using either lan port 1 or 2, and thereby relaying information across the network so that it can be monitored remotely. How is this configured in the gateway? We're rolling out a...

In thread thread690-1745537, it was asked how to load the shellshock remediation onto CM 5.2.1. One answer said that you can use the web interface, the next response said to use the linux command line. Which way can you do it? Can you go either way? Just needed some clarification. Thanks.

Is there a way to push patches out automatically? We've got over 100 sites with LSP's and media gateways and a duplicated core switch. We're doing System Platform patches and CM patches now, but are doing them one by one, which takes a LOT of time. Is there a way to automate this?

We got a site with an S8300/G450 with a 6 member trunk group of CENTREX lines. We had an issue not long ago with dropped calls. LEC says they found no issue, they left and it started working fine, go figure. Now, we are getting echo intermittently on a few calls every now and then. Any ideas? We...

We're about to upgrade a duplicated S8730 server from 5.0 to 5.2.1. I've got the latest service pack and firmware updates, and have made sure that the ip phones do not get their firmware from the S8730's. Are there any other gotcha's I'm overlooking? Seems straightforward from here. I saw a...

thread690-1644618 Did anyone find an answer for this one? I'm in the same boat. I've figured out duplication link and services port, but I need to know where to plug Control Network A, B, and corporate LAN. Thanks, Barry

We're about to upgrade our old CM 3.0 to 5.2.1. I'm looking at our hardware and I'm trying to determine if we have Control Network A and Control Network B or is the IPSI's merely duplicated. Is there an absolute way to tell??

How can one remove a member from the MGC list on a G430 without wiping out the whole list? I only need to remove 2 and keep 2. Thanks. Barry

Okay, so we added an additional ess site. An existing ess site, which has all ip phones, now has an issue. The ip phones have no dial tone on handsets, but they do on speakerphone, ALL sets. Any ideas?

We're installing a MAS/MSS setup. The MAS server came 'preloaded'. However, when going into Component Services and trying to start the MM Messaging Application Server service, we get 'ERROR 1075: The dependency service does not exist or has been marked for deletion.' So an Avaya MM Engineer...