Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
clear pix startup-config
I have pix 515 ver 6.2(1) and I need to erase the startup-config. How do I do that? I issue a clear configure and write erase memory but my startup-config still remains the same. btw does the pix have NVRAM too. It seems like the IOS and startup-config is stored in flash base on the book I'm...- kapupu
- Thread
- Replies: 2
- Forum: Security, hacker detection & forensics
-
Pix Firewall
I starting to learn about Pix Firewall & I have some issue with it that I need some advice. My Pix is version 6.1(1) The issue that I am having is that when I'm trying to type interface ethernet0 it still put me in global configuration mode. I could never get me into the interface configuration... -
openSuse
I'm new to openSuse and I need some app to connect to cisco router though the console port. I installed me Putty but I'm unable to connect to it. the error message I get is unable to open connection to: unable to open serial port my serial line setting is /dev/ttyS0 -
CIDR & Route Summarization
Is CIDR & Route Summarization the same thing? -
Native Vlan & Management Vlan
Can you put some host in the management vlan and ping the regular Vlan host. I try this but I cannot ping them. -
PVST+ & Rapid PVST+
Ok is it safe to say that there are 2 type of loop avoidance for layer 2 switch. They are STP & RSTP: STP can use PVST or PVST+ to prevent loop RSTP on the other hand can use PVST+ OR Rapid PVST+ Am I right? Any input would is appreciated. -
trunking protocol
My question is how come the trunk is not establish? SwitchA config interface FastEthernet0/1 switchport trunk encapsulation dot1q switchport mode trunk A#sh vtp status VTP Version : 2 Configuration Revision : 1 Maximum VLANs supported locally : 68 Number of... -
redistribute static
So I got two router connected and all communication is working and I'm using RIP. Now I have router A and B and I want router B to propagate a static route so I issue this in router B ip route 192.168.1.0 255.255.255.0 loop3 router rip redistribute static When I check router A routing table I...
