Search results for query: *

Hello, Question for you cable gurus out there. Currently, we have 2 1.5M bonded T1's coming into our CPE, then 1 T1 cable that runs into our phone system. We are going to be moving our phone system out of the water heater room that it is in now, into our data center. Would I be better off...

We have 2 MICS cabinets, each with a PRI card. One is running version 4.1 and the other is version 7.0. Is it possible to swap the software on these cabinets and maintain all of the programming?

Just recently bought 50 pair CAT3 cable for a telephony project and need to terminate each end. I cut the cable open and I can't tell where the pairs are. Up until now I have only used as high as 25 pair cables. Can anyone lead me in the right direction? I tried Google to no avail. Thanks!

Does anyone have any paging experience with these units? We are trying to tie the paging amplifier at our branch office into the main office phone system. If possible I would like it to have its own zone. Any ideas?

Can anyone tell me if these units are capable of tranmitting analog lines, or do they have to be digital, then converted to analog once they get to the branch? Thanks!

Does anyone have latest/semi latest firmware for the RNM08/12 and SNM08/12? I'd rather not have to buy them from Citel for $500 each. Thanks!

Can anyone tell me why my RNM12 unit is getting stuck at Auto Detecting console modem... Please wait AT Also, is there a way to reset the unit to factory defaults? I cannot seem to find much information out there on these units. Thank you!