Search results for query: *

I have a device (Sensaphone 400) that requires an analog phone line. I attached it to an analog port on the NEC SV9100. When called, the device will answer and give status information in a computerized voice. The problem is that it only answers if the ring cadence is set to one second on...

I want to allow outside callers (employees) to call our main number and, during the auto-attendant greeting enter in the previously disclosed system park retrieval code and connect to the other outside caller who is on system park. First, I've changed our system park retrieve code from *6 to 6...

I use Valcom V-2006A paging controllers which interface to my NEC SV9100 via a trunk port. The Valcom unit provides dial tone and accepts DTMF digits to choose a zone over which to page. I have a large number of analog phones and users don't know how to hang up properly and end up sending a...

Is there a way to universally block all calls to 976 dialed as NPA + 976 + XXXX or 1 + NPA + 976 + XXXX? The "Toll Restriction - Common Restrict Code Table (21-06-05)" only allows for 10 entries and simply putting 976 in this table does not block calls dialed as ten or eleven digits (who has...

I would like to set up ARS to automatically insert a 1 in front of a 10-digit number. I set up dial treatment #1 to look like this: 1E. I then set up my ARS table entry to contain 10 @ symbols, the correct F-Route, and dial treatment of 1. It's not working. In fact, it doesn't appear to...

I saw this question asked before but have not seen any replies that address the issue. My system consists of four Option 11C's (25.30) connected using ITG cards that emulate tie lines. It has a coordinated dial plan. Here is what is happening: SCENARIO A (good) ----------------- 1. Outside...