So, I've got a Magix R2.1 and it is having an issue with the System going busy for no apparent reason. Users report that over the past 24hrs they have had 3 occurances where the phones start beeping and the displays read 'Wait, System busy'. I've looked at the access logs and the only entry is...
System: Merlin Magix
Release: R2.1 v8.0
Mode: Hybrid/PBX
Trunks: Single PRI
Issue: I have a user set up to be able to Remote Call Forward his extension to his Cell phone.
Set Type: 4412+
Remote Forward Allow = Yes
Trunk Transfer Allow = Yes
I have added a Transfer button to the extension...
Have a Legend R7, working for years with a single PRI from LEC. We are adding a 2nd PRI from our Cisco Router for Intra-Company calls. The PRI is programmed and works on inbound calls. Having trouble on outbound calls. I have the channels set up in pool 8 and phones have pool access 8...
System: Definity G3R R011r.03.0.526.5/Intuity Audix 4.1-5
Issue - One extension is not getting MWI.
What's been tried:
1. Removed all messages from mailbox, cleared amw all and left a message. No MWI
2. Removed subscriber from Audix and re-added, left a message. No MWI
3. Removed extension...
Home built PC which has worked for years will not boot past post. Scrolls through post than screen goes dark and hard drive does not run. I have gone to bios and saved safe settings,no change. The monitor is getting signal (power light stays green). Hard drive does show a little activity...
We have a Merlin Magix R3, two cabinets, with a PRI for outside calls. Layout as follows:
Proc
100D - Tandom tie to another Legend R7
412 TDL
024 TDL
024 TDL
100D - PRI
Merlin Msg
016 TTR
024 TDL
100D - To be used for intra-company tied to Cisco (not set up yet)
024 TDL
We reconfigured the...
Using an IP Office 500 R5.x (haven’t decided on specific release yet)
Sole purpose is to act as a conference bridge.
I have built a config with aprox 70 Conference Meet Me short codes. Each short code represents a specific ‘location’. About 10 to 15 bridges may be active at any given time with...
IP Office 500 R4.2
Lic: IPO IP500 Voice Networking RFA (4 lic pkg)
202966
I have called my BP but responses here are typically quicker.
Scenario: It is a single site but due to distance constraints will need system at each end of the location.
- IP Office 500 R4.2 at each end; Side A, Side B...
Have a remote office with one phone and one fax. Want to convert to an IP Phone and use a VoIP Analog Converter for the fax to eliminate two POTs lines. Does anyone have experience with any of the VoIP analog converters? Any compatibility issues? Quality of service issues?
I will be setting up an IP Office SCN to replace an existing Merlin system which is operating in tandem across a T1. It is more than 3500 feet from end to end. IT has not approved VoIP on the network for IP endpoints, so IP phones are not an option at this time. So, traditional Digital and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.