Search results for query: *

Can you program an NXX in an opt 81c running succession 3 as a single digit. Having all 2 , 3 , 4 ,etc. going to the same rli?

I have an 81c with succession 3.0 on it. We have been redoing the cabling on the TN side. Going from 66block to wire wrap. I have been using the mov command in LD 25 to move whole analog cards. The digitals I move one at a time and no ACD sets are being moved. It has been working fine until we...

I am having problems getting my system monitor cards NT8D22 working in my 81c. I have double and triple cheked all the dip switch settings. I have tried new cards and cards that I tested in my 61c that worked fine in the 61c. I did notice that in the installation instructions it shows an...

I have 4 opt switches 2 81c and 2 61c. They are all networked together via cdp with 2 PRI's between each switch. Is it possible to route intercept treatment for all the switches to 1 central MIRAN card?

Anyone have any idea why I can recieve data but not send to my NT8D41 Quad serial data interface paddle board? I have tried DTE/DCE and different buad rates.

Do I need a keycode or anything to use a MIRAN card in my 81c, or can I just buy one plug it in and setup some routes to it?

Can anyone tell me hoe to set up intercept to go to voice mail?

Is ther a way to configure an intercept to ring a DN via a universal trunk card or something else? I ask because my Boss bought 6 recorded anouncers and they only recognize ring voltage.

I have an 81c running 3.0. Monday I came in to work and found core 0 dead due to the CE PWR supply having gone out. I replaced the CE PWR supply and the shelf came back up, but the core didnt. It says I have a single core when I stat cpu in LD 135. The SYS Utility light is red too. I have...

I have an OPT 61c RLS 3.0 and have been having some problems with people not being heard when they place a call from the 61c to an internal or external number, but if they put the call on hold then retrieve it from hold it works fine they can be heard. This happened about 4 months ago and I...

How do I enable the test line in LD 15 for an 81c? I have one that works in my 61c's, but I can't get it to work in any of my other 81c. I can program the numbers in the t100 and ref0 and so on but all I get is a fast busy when I call them. I see that in the Alphabetical list of prompts page 367...

I have an 81c that has a Clock controller QPC471H in net grp 1 shelf 0 that is working fine. However the clock controller in net 1 shelf 1 is not working at all, when I try to enable (enl cc 1 fdl) it it give me a DTI068 that say "System clock generator is not responding" when I do ssck 1 it say...

I have an 81c that has a Clock controller QPC471H in net grp 1 shelf 0 that is working fine. However the clock controller in net 1 shelf 1 is not working at all, when I try to enable (enl cc 1 fdl) it it give me a DTI068 that say "System clock generator is not responding" when I do ssck 1 it say...