Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: hwking
  • Content: Threads
  • Order by date
  1. hwking

    ISDN protocol for taipei

    does anyone have any experience with mitel icp3300 PRI in Taiwan. What protocol to use? Mitel told us NI2 but while the D channel is up, we cannot make or receive calls.
  2. hwking

    E1 PRI DCH on channel 16

    Anyone know which setting (CNTY setting presumably) to use to set the DCH on channel 16 of an E1 PRI, rather than channel 31? I'm putting an E1 in Bangladesh. I chose ETSI for the CNTY prompt. The telco there says they're receiving my D channel on channel 31 but they want it on channel 16.
  3. hwking

    Connect Mitel ICP to NORTEL CS1000 with SIP

    I have connected a MITEL MCD 5.0 to CS1000 6.0 with SIP. Calls are working in both directions. but I notice that when the CS1000 calls the Mitel, there are two call attempts. The first fails and the second succeeds. With wireshark, I see: from CS1000: SIP Invite from Mitel: Status 415...
  4. hwking

    Installing Loadware in MC32s

    Does anyone have experience in updating the MC32s card in CS1000M Release 6? I have an operational MC32s. I need to upload two new loadware files: DSP2AB03.LW and MGCMAB01.LW. The NTPs, and Avaya's advice, is load them (in Element Manager) via File Upload and then do an upload under Voice...
  5. hwking

    err648 on release 6 upgrade

    I've just upgraded a Rls 3.0 Opt61 to Rls 6. The ITG card was replaced with a sig_server/MC32s card. I programmed the IP trunks as IPTI. Now, I get a err648 (No TN for ITG card) on both inbound and outbound calls on this route. Anyone know what causes this? I've got all the patches in the...
  6. hwking

    Programming a Route for Bell Megalink

    I got a Bell Megalink circuit. 1 T1, 5 LDNs. Bell is not providing any information on what that means for my PBX. Does anyone know how this should be programmed. I presume it is an ISA route, but not sure. I've tried programming an ISA with COT trunks, but get call barred. Does anyone have...

Part and Inventory Search

Back
Top