Search results for query: *

We have incoming analog DID's and I am trying to figure out how they work (we're changing to an asterisk phone system). Does the analog DID basically act like an analog phone connected to us? I know that when you dial one of our DIDs from the outside world you can hear the telco using dtmf to...

Hey guys, I have an MC32 acting up. I cannot for the life of me remember how to disable/enable it to reset. What ld is it? It's slot 10 on my system .. grrr. I curse myself for loosing old logs where I did this a lot a few years ago.

CS1000 involved: We're changing our ld lines to another switch (already connected to the cs1000 via pri, functional). Currently, we dial 4 to access ld lines (8 tie trunks on the cs1000). I need to re-route that to the other switch across the PRI. I've been doing a lot of searching...

OK guys . .I'm stuck again:(. I have two CS1000M cabinets (both 4.0), connected by 8 ip trunks, call them Main and Remote. I have a phantom dn setup on Remote (pasted below as tn 65 1, 4 digit dn). I use rcfw to forward the phantom dn to a 6 digit dn, which routes across the ip trunks to...

ver: CS1000M, 4.0. We are in the process of building out a new switch (asterisk) and have a tmdi pri tie trunks between the nortel and asterisk. The nortel is the main switch at this point and receives all pstn calls via pri did. We are primarily 4 digit extensions, but to route to the pri...

Hey guys, I've got this thread over in the Nortel area since I "think" this is a Nortel programming issue, but thought I'd cross post over here. Anyone have any pointers? I'm using NI2 and can call Nortel->Asterisk fine, but not Nortel->Asterisk. The thread in the Nortel forum has the debugs...

OK guys, I've had a tech on the phone with me on and off for two days. I'm trying REALLY hard to get this setup and functional, but not having any luck. We originally setup the TMDI PRI as NI2 (same on the asterisk side) and DID the PRI came up great. I could place calls from the Nortel to...

I have two CS1000 switches connected via ip trunks. We changed our core switch (layer 3, also routing) out yesterday and everything was fine. This morning, you cannot dial between the two CS1000's. In ld 96, the dch's both said EST, yet no calls would pass. I'm not sure how to debug...

Hey guys, I need some help. I've got an opt 11c that I need to get overpaging functional on. I've got a Bogen 24V ps and horn to test with before we purchase all of our equipment. My Nortel experience is limited to MACs for the most part, but I can follow instructions easily and have...