Search results for query: *

Can this MGC card co-exist with the MGC DW60? Thanks

I have 4621SW IP sets that when plugged in boot to this: DHCP: 21 seconds,22,23,etc. VLAN ID-855 Is there a way to defualt these sets or boot interrupt so they can be used? Thanks

Is there a way to view what extension range is being assigned by our IP400 to our IP sets? I would like to limit the range to 4 digit extensions that begin with 6, is this possible?

Is there a way to retrieve the serial number off of a 2410 set running on a G650? Thanks

Is there a way to rerieve the serial number off of a 2410 set plugged into a IP406? Thanks

I have 2 G650 cabs. The 2312 IPSI board in cab 2(A02)has a red light that remains lit constantly. It is the ETR light below the display. There is no dial tone in cab 2. Cab 1 seems to be working fine. I have swapped out IPSI's with the same results. Any ideas?

Cannot get a 5610 set to work on our IP Office. The display reads; 1007: NoUser B 1503 If I hit numbers on the keypad it says incompatible disk. Is DHCP automatically turned on in IP Office?

Is there anything different that needs to be done regarding these sets? I cannot get them to register to our 8720. We get Incompatible error on display of 5610 set. All other sets seem to register fine.

Existing system, first time trying to access. Cannot access through serial or services via direct LAN. Serial printing garbage on 9600,8,1,N. Laptop setup for 192.11.13.5 trying to access 192.11.13.6. No go on both.

Trying to default One-X 4610 IP sets. Don't know passwords on these sets. Is there a way to default or a work around without knowing the passwords? Thanks

I cannot get dial tone on any digital ports on an IP500. Analog is fine and it does see the digital control units but no DT. Any thoughts?

Trying to download IPSI firmware43 files from laptop to S8720 server using web interface but times out. Can ping and upgrade existing IPSI's but cannot download new file to server. Am I missing something? Any thoughts?

Switch not switching cores during midnights. All programming is good. Can manually switch but not during midnights.

I do not get the option to program a 5610 IP set on our S8700 server using Site Administration. Is there another type of set I should use in programing to get the 5610 to work? Thanks

2 group FIJI. Cannot enable Peripheral signaling in shelf 1-1. Comes back UNEQ. Any thoughts?

Is there a prompt in CLI to find out what release/version software is being used on the 350?

Do the new FIJI's have to coexist in the same ring group or network group?

I can get the G700 to register but when I web in I get a "Clock Syncronization signal is lost" under Fault messgae and Operation Staatus is fatal. Does anyone know what this means?

Trying to install a G350 (without S8300) using IW. I have installed a G700 using IW successfully registered but this menu is different. On the 700 I progranned 4IP addresses, stack, mgc, controller and Voip. What IP addresses or other inputs do I need for the 350 to have it register? Thanks

How do you retrieve the release info from a 3X8?