Search results for query: *

Does anyone know if there is a patch for TDS005 errors on release 5? Nortel stated that this was fixed in release 4.5 but we are now getting them on a realese 5.0 system

I have a site which is forwarding their number to site B. Call lands but when it goes to the Call Pilot it states that you have been forwarded to a voice mail system however the number you dialed does not subscribe to the system. I have a SFA on the receiving end set and have the DN associated...

Does anyone know how to stop this message from occuring every 15 seconds? I have stated monitoring and it is showing off. DCH: 24 MAINT INDICATION TIME: 13:45:48 COUNTER VALUE 10 255

Does anyone know what the Telephony LAN (TLAN) DSP IP address is used for in the programming of the card in EM?

Does anyone know where to setuop QSIG for T1 connection from a Nortel to Avaya PBX?

Has anyone experience the nane display on some sets displaying xxxx instad of the name? We recently upgraded to release 5 and it only happens on a few sets even though they are programed the same as a set that works.

I was experiencing ERR5417 on 24 0 0 11 and 15. This was an analog card but there was nothng on unit 11. I moved all the units that were on 24 0 0 and moved them to loop 12. That cleared the ERR5417 but now I am getting ERR020 on 24 0 0. I tried to out the card but it tells me that it is...

I have a Option 61C running on release 3 and when you redial a long distance number you get a fast busy and DCH messaging is stating call rejected. I am thinking it is from the carrier but wanted to know if there might be timers on the pbx before opening ticket with MCI. It does not do it when...

I have 5 sites that have ITG cards that are 3.0 or higher that have to register to a release 5 NRS CPPM co-res SS/nrs. I have configured it and have 2 sites registered but am getting that the incomming call is barred. Does the PNI have to match or is there any special programming that is...

I have just upgraded a 61C to a 1000M SG and am getting continous AUD019 which was pointing to a TDS/Conf 0 0. I have replaced the card and still the same issue. I have isolated to Superloop 12. If i disabled (loop 12)it the AUD019 stop and a clean AUD000 comes up. I replaced the newtwork card...

Does anyone know if the ESDI513H is compatable with release 5?

We just upgraded a 81C IGS to 1000M FNF MG. The upgrade was sucessfull but i am getting a DTI011 error when I tried to switch clocks. I have checked cabling and clock settings and they are correct. Any idea?

I am trying to load a patch remotely to an option 11c. I know the pload, pins command in PDT. Does anyone know the steps to load it from the PCMCIA or from desktop to the u/Patch directory. I believe I have to TX and RX from procomm???

I am having a problem dialing one local number. I can direct select the trunk and dial out but if dial 9 and the number, it gets reorder. If i put a disa in the pbx i also can call out. has anyone ran into this?

I am trying to load the deplist to 1000M release 5W switch. i am doing "MDP INSTALL R0/cpp4.zipp" what is the drive letter for the RMD??

I am looking for the software that MS Outlook uses to play messages from CallPilot. Where do I get this?

Does anyone know the system mailbox limitation on a CallPilot 201i?