Search results for query: *

Hi I have 2 pbx CSE 1000 7.6, the site A has a voicemail Octel connected and the site B was connected before for a PRI to the site A. the lamps working ok, but I have to change the PRI for Ip trunks (SIP) and now the lamps at the site B are not working when someone has a message, I checkef the...

Hi I have an Ip office 500 connected with H.323 to an LG-Nortel Ipldk60, the calls between the extensions are working ok, the problem that I have is when I try to call from the LG taking and ISDN pri trunk of the Ip office for an external call....checking at the Ip office system status I see the...

Hi I have an Ip Office R9 (IPO)connected via H.323 trunks to LG-Nortel, the calls between them are working extension to extension. The problem that I have is that the users form the LG need to make call using the T1 connected to the Ip Office but the user received a disconnected tone, I made the...

Hi, I have an Ip Office 500 with a T1-PRI connected , before set up the DID to the telephones, the outgoing calls work fine, but when I set up with the MSU tool the DID to the extension, I can not dial out if that extension has a DID...if I deleted the DID (for the incoming route) I can dial...

Hi, I have a CSE1000E r5,I set up a second T1 ISDN connection with IFC ess5, the problem is that some channels are FE MBSY, I tried to disable each chanel and enable again and still are FE MBSY but if I make a dial in call the chanel get idle, Then I have to make some incomming calls to put all...

Hi, I have an Ip Office 500 and other Ip office 406, the customers has a link between the buildings then I need to set up the configuration to connect them at the same network... before the customers has other connection with vlan toward a carrier but the connection changed to a direct...

Hi I tried to install a keycode at the CSE1000E, I received a file .kcd, and I copied to the rmd card with the software of the CSE1000 at thE kEYCODE directory. At the LD 143 a use the command KNEW and appear a menu with the keycodes inside in the directory KEYCODE, then I selected the new...

Hi, I'm trying to integrate the CSE1000 r 5.0 with the exchange, but an the siganaling server doesn't appear the tab for Microsoft unified, any one has an idea?

Hi, I recently installed a cse1000E rls 5.0, and actualized the deplist, after that the Digital and Ip phones after I release the call the chronometer of the duration of the call continue, and I can dial other call.... Any idea?

Hi I tried to do an upgrade to cse 1000 E rls 5.0 and I have the following issues: 1.- Some cards MGC NTDW60 are no working fine, I can not set up them because when the cards start to BOOT Up , below is the capture from my laptop Found device : INTEL 82365SL Engcode...