Search results for query: *

thread798-1698595 So my previous post indicated that our vendor hears noise on the overhead speakers off the paging amplifiers and the electrician with very little voice experience was trying to eliminate the noise with shunts and grounding the shielded cable that was being used. Fiber was...

Does anyone use the snmp feature that updates the CS1000 Gui interface if someone makes a change using command line? If so can you share the procedure or where the installation document lives and if you are using how do you like it? Basically if you have techs who don't use the GUI and a help...

Maybe someone can help here. Existing paging system uses UTC, loop start. Local electrician ran 900 feet of direct 24 gage sheilded line. Still picking up 60 cycle hum and 1.3mghz signal on the run with nothing attached at either end. Basically a big atenna, so the powers that be want to run a...

Anyone using audio codes where the E1 is using Euro instead of ISGF on the Dchannel setup. The pbx does not have pgk 305 so IGSF is not available and we want to use and existing Audio Codes box for SIP access from the opt11c.

I have a sip route setup to with a Cisco call manager. The soft phone I am using can ping the cluster IP however the pbx it is registered to cannot ping the cluster. No route found is the message when making the call to the cluster from the pbx. ROGRESS: ORIG ADDR IS NOT ISDN CALLING #:61057051...

We have a site where the softphones register ok get dialtone but once they complete the dialed number whether on-net or off-net the call fails and re-order tone is presented. You can reach the site fine via ITG and tdm phones dial out fine over itg from that site. The softphones are register...

Anyone ever seen this bug before, dchannel error? Carrier? any ideas? Looks like the it happens intermittently and I see no counter error on the pri. Thanks BUG4304 % BUG4304 + 1067E160 106A6F4A 106A6DF8 104EFD1A 104ECAF6 % BUG4304 + 104EC598 106B8C0A 106B89DE 106B77AE 10CEC808 % BUG4304...

Anyone using an Audiocodes box on an E1 qsig pipe, if so do you have the setup for the audiocodes side for trunk configuration? And are the channels 1-31 or 1-30? Thanks.

I have an active hacking situation, how do I drop current line? Also does anyone have guide lines for securring the BCM. Currently they are getting into the mail system and getting out. I have added the numbers they are dialing in the restriction table but they have multiple numbers they are...

The 'Login' authentication method is disabled. Please contact your administrator. Anyone ever come across this error above login into the callpilot rel 4.0 using desktop messaging?

When under services the BCM returns the following. "Telephony programming is not avaiable. A connection to the MSC has not been established. Plear try again later." BCM 400 release 3.0.1 Build 7 iss 1. Any ideas anyone anyone bueler?