Search results for query: *

I can't seem to get the printer to show me what document is printing when I select ABOUT THIS JOB from the front panel. It used to tell me the name of the document or web address of what I was printing but now it just says "RECIEVING AppSocket". In PhaserLink Job Accounting only the ip...

I have a Phaser 850 and the left jet stack thermistor is bad. I have disassembled the head and found where the thermistors are embedded and where the signal emerges on the ribbon cable. Does anyone know what brand (prob Tektronix proprietary) and type of thermistor is used and where one might...

I have an 850DX that initiates a full cleaning cycle every time I send it a job that brings it out of standby. It wakes up, quickly gets to around 50% warm then invariably (and unavoidably) goes into cleaning mode. I keep it on at all times and have it connected to its own UPS. It is set to...

Anyone know of an easy way to send the 850 series into standby mode quickly? I don't like that it waits 3 hours after I finish printing to put itself into standby. Here is what I do, it is not quick but it works, though there must be a better way. Perhaps a script or some command that could be...

If you are getting error 15,004.45 and your bulbs look ok then read this. I finally figured out why my 850DX was taking so long to come out of standby and too frequently pausing print jobs to display "Warming Up Please Wait". The bulb contacts were burned and pitted, I removed the drum heater...