Search results for query: *

My customer has a MICS 7.1. I have set all phones to appear only, with the M7100 courtesy phone set to NO line appearance. The voice mail is programmed to answer after 2 rings (to get the caller ID). The M7100 still rings for the 1st 2 incoming rings on all calls. I have made sure that there...

Have a customer with 4 hunt groups on a o x 32 rev. 6.1xc. Incoming answered by a fibre NAM. CCR option 1 goes to hunt group 01 (707). CCR option 2 goes to hunt group 2 (708) etc. If no one answers the call just rings and rings. Why isen't it going to a mail box if unanswered? Several extentions...

Will a Flashtalk2 rev. 2.0 work on a 308 k.s.u. DR-5 (green label)?

Has anyone found a way to find a lost installers code on a BCM yet. The HEX code tables for MICS and CICS are invaluable, but can't find similar tips for BCM.

I have a client with an MICS rev. 5.0 and a Flashtalk2 rev 2.0.01. The volume on inbound calls is very low when it goes through the AA. I've changed the Caller I.D. cards and the voice mail. The volume directly on the underground is fine. Any ideas?

Installed a doorphone on a BCM 50 rls3.1. New doorphone NT8B79FE6. Button on doorphone is lite, push button and you get tone in speaker. Cannot access programming (feature 9*4). It tells me "inactive feature". Go into maintenance and the port shows "idle", device says "doorphone". Dial the...

Have customer with MICS rev. 4.1 software. 29 telephones out of 48 are in ring group one for night ringing. in night mode the receptionist's (221) rings once before the ring starts. As the voice mail picks up after 3 rings, this only leaves 2 rings to grab it. I tried removeing 221 from the ring...

ON a MICS 7.1, have a ringing group with 5 members. Only 4 of the group ring. I can't get the 5th to ring. I changed the set, changed the port and copied a ringing set's parameters, (system and data), to the non ringing set. Still no dice. Any suggestions?

I have a client who frequently gets voice messages that are fast busy tones. This is a CICS with CallPilot 100. The lines are set to supervision and I have verified with the carrier that superviion is on the line, SO...why isen't the system dropping the call when the caller decides to hang up...

On a flashtalk2 rev. 2.0.1, I set up path 0 with path 1 as a sub menu. When I try to program path 1 1 it offers "menu" on the left hand soft button, but when I press it, it says "no path available". Would Nortel really offer an option button for an option that is not available?

Does anyone know the total amount of recording time in a Call Pilot 150?

I haveaproblem with the new T7406e cordless. I have installed 2 in the last week with the same problem. On a CICS 7.1, the handsets (in each case 2) start flashing on the screen "line 1, intercon, function, line 1 etc. " and the appropriate lights on the handset light up. Each item flashes for a...