Search results for query: *

Trying to get an SEB2 (not NetPath) to talk to me via Procomm+. Used both local and host1 interfaces. All baud rates 8-N-1 with and without modem eliminator. Procomm shows connected but no data whatsoever and no response to CR or any other keys. Tried multiple units with no luck. Anyone...

Does anyone have disk2921.sys ? Trying to load an old 3.0 for testing IODUC Thanks Brison

We have a customer that cannot transfer calls from stations 226 and 250 to stations 225 and 251. This system was set up long ago - pretty large MICS. The phones are in 2 separate suites. The main receptionist can transfer calls to these stations. These stations can intercom each other. Is...

Can we replace a G700 expansion cabinet without reprogramming the system? Is there a procedure that someone can point me to (assuming it's more than power down and physically replace)?

Is there a way to get status on a digital station circuit pack in ASA? I'm remote so I cannot see the indicators on the card.

Looking to have some, but not all, DIDs on an ISDN/PRI forward to Night Service. Is this possible w/o vectors? Thanks Brison

We have a customer with Prologix/Audix. When I list vdn, it throws "vdn" is an invalid entry. Same with Vector. Any idea's why I cannot see or, consequently, build vectors on this system?

How do I change the received # length from 3 to 4? Right now says I have to enter 1-3 digits. DID is 0997 and it won't accept 997.

removed dlc - outed the 3903s but cannot add cardslt. sch0120. CS1000 small system with 4 slots. card is slot 2. stat shows all tns uneq. It's been a decade for me - was pretty sure I could out the card in load 11 but I get the sch0120 when I give the out, cardmlt, 2 command. does not seem...

I am converting a BCM450 from copper trunks to PRI. I was not able to assign blocA to route 000. Built 001 using 8 to dial out (it would not let me choose 9). We will be getting rid of the copper lines. Can I assign route 000 to blocA in order to allow users to use 9 to dial out?

We have 2 6140 handsets that have had the admin password changed and we do not know what it is. When we use the HAT, we cannot make any changes without entering the old password. We've been through all of the Avaya documentation that we can find to no avail. Brison

I have a BCM400 rel 3.7 that I cannot log into. Company downsized and there is no record of password or ip address. I have used BIT to reformat drive, but telnet is unresponsive (not 100% sure I am doing it correctly) and have had no luck finding the IP address to try to access via lan. Any...

I am attempting to install a 3.7 to 4.0 upgrade on a 200. I get the message about the MSC card and to check that telephones are working. All digital sets working just fine - no IP on this system I do get the same error when trying to apply a patch. No patches on system currently. BFC looks...

We have a customer with a BCM50 that is losing 15 minutes per day. System is rel 1.0 with all current patches successfully installed. We have changed the battery as well. Has anyone experienced this issue?