Search results for query: *

Can anyone supply PASAI and TLU 80 1/4 connector programming and wiring to the Ascom 942PX module?

We are setting up a VSU to play a welcome and queue message on an incoming trunk call via an E1 to a Common Operator. We have set up the CORGS, CALT and RA commands but it will not play. Internal calls to the OC work fine, ASPAC 116 set up for internal and external calls. Any ideas why...

I need to add a new DID number to an NBX 100 with r604 SW and a PRI. What are the steps? I know this is done in the Dial Plan but I am not exactly sure about editing the file and importing it back into the system? Will it cause the system to reboot?

We have holiday greetings set up for Memorial Day, 4th of July etc. in our AA - TD Greetings. The problem is when I select a greeting - for example memorial day and I tell it to play on Time of Day and Date Range for a certain exisiting AA it will not play - What am I doing wrong?

I am trying to connect a remote LIM via CAT5 with a GJUG4 ROF1314247/4 and the L board is a GJUL4 ROF1314246/7 R3A. Does anyone know if this will work and if so what are the TX-RX pins on the boards?

Having a strange issue with a 3COM NBX 100. We have 2 sites, The main site is connected via a point to point T1 to the remote site with 3Com Routers and an uplink card in the remote cabinet. Whenever we make any programing changes no matter how small we loose the remote site cabinet and phones...

Has anyone tried to connect a LIM back to a GSM using CAT5e shielded cable on the 120 ohm ports? In this case the distance is less than 150 feet.

Can anyone suggest the ROCAI, RODAI and RODDI for a TLU76/1 to an Astersik box? The MD will be user side and the E1 will be a tie line. Thanks

can anyone verify the procedure for "follow me and group hunt follow me? I thought it was *72*xxxx from an extension where xxxx is the follow me point amd *72* xxxx*yyyy# for a group xxxx is the group you want to forward and yyyy is the ansering group?

Having trouble setting up a new CP150, changed the IP from defualt via serial to 192.168.1.50, laptop to 192.168.1.1 subnet 255.255.255.0 on both Launched IE - http://192.168.1.50 to connect to CP manager to initialize but I cannot connect? IE Says it opening the page and then times out. Any...

Need some clarification on programming a headset key on the Dterm phone usinf CAT My Steps: 9000>142,01 (DE) Displayed 9000>142,01:142- I entered 1090 EXE Data Not Found was the response. I noticed the manual says F1090 - does this "F" need to be entered and if so - How?

All, We are new to the NEC IPS 2000, I just need to know the steps to programming a headset key on a dterm phone that will allow a user to toggle between headset and handset? All advice is much appreciatted!

Hi All, I need help programming a Mitel SX200, i need to add 1 loop start co line. Can this be done via a phone or hyperterminal? I know the SW is lightware 19. What steps need to be taken? Thanks you.....