Search results for query: *

Hello everyone, I replaced a 403 with a 406 and load the 403 config file in the 406. But for some reason the extensions in office manager do not match the extensions on the patch panel. For example, what's plugged in the 1100 slot shows up as extension 1107. Any ideas on how to configure office...

Hello again everyone, I have a trunk line coming into the TLU76/1 and this is the fault code: Fault code 274, Digital Trunk, clock Malfunction. I am assuming that I didn't setup the synchronization, frame, or rate, something having to do with the clock rate or speed for the specified route in...

Hello, I am in the process of setting up an ISDN (Q.921, ETSI) connection. Can someone tell me the sequence of commands and boards that play an integral part in setting up an ISDN connection? Using board TLU 76/1 Here is what I gathered so far. I. TLU Board configuration • CNHUI • ROCAI •...

when making a call, the call fails and never connect. Below is the printout from Sysmonitor. You can see the call begin, but then it goes down hill from there. I am assuming this line, "11mS PRN: Line 5: Manual: Line Loopback Up" is part of the problem, I never saw Line Loopback Up before, what...

Hello everyone, One of the alarms listed is Fault code 106, The one having to do with faulty I/O board. I tried to administer the various test under the FIFTI command but it says my subsystem do not exist, when the system is either SYSDISK1, SYSBUFS11, OR SYSBUFS12,I tried all of these and it...

Hello, Can someone please tell me how to configure the ethernet port on the NIU2 as a MML port? Thanks P.S. I am able to log on to the system now, we created our own V.24 to serial cable, lol.

Hello again, Do the NIU2 have a preset IP address? If so what is it? and where is it in Alex. If not, then how do I telnet into it? Thanks in advance

Hello, All of a sudden our avaya 403 stop receiving incoming calls. When calling in, you hear a busy tone. Any suggestions will be helpful. Thank you

Hello, My company have MD 110 still in the box. I read Alex and know which cables go to which units, but I don't know what to do after I hook up the cables. For example, I know the NIU2 card via the appropriate cable can be connected to my PC, but then what, how do I know where to telnet into...