Search results for query: *

We are using Cisco 7920 phones. We have Cisco controller based wireless. ~ Problem - The phones work good, but do not display the name of the access point they are connected to when you look in the site survey section.

How Do I set a WCS controller to be a backup controller to my primary controller? Thanks,

New to login scripts Can anyone direct me to a "beginners" guide to login scripts. Thanks,

Here is the current configuration I want to use for my 2621 router as a firewall. Please make any suggestions that will help me use this router as a good firewall against incoming traffic. I have not named the router or set any of the passwords yet. I will before I go live with it. ~Is there...

I created the following ACL ~ access-list 102 deny icmp any any ~ I want to deny ICMP ping to my 2621 router on the public interface f0/0. ~~~~~~~ Router#config t Enter configuration commands, one per line. End with CNTL/Z. Router(config)#access-list 102 deny icmp any any Router(config)# ~~~~~~...

Is this a good fire wall? Is there a way to log the traffic it is passing and blocking using ACL?

If I apply any one of these ACL to my f0/0 interface - pointed toward the internet, I instantly can't ping past the router in or out. I apply the ACL to the f0/0 interface - "in" > ip access-group 102 in ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ access-list 102 deny tcp any any eq ftp...

I have 2-2600 routers sitting beside each other connected together over a DTE\DCE serial cable. To one of the routers I have a 3550XL switch connected to. Any PC I plug into the switch is really-really-really slow to the network or internet. Thoughts? ~ If it is configured correctly should I...

Ok, I got the router going. I need some help with ACL. I don't want to block anything going out (from my private network to the internet)I do want to Block stuff coming in. I have been reading ablut ACL, it can get complicated quickly. Interface f0/0 is pointing toward the internet. I do know I...

I want to hook this up CABLE MODEM - 2621 - 2950 - PC Problem - When I try to configure f0/0 to get DHCP address from cable modem I get the error. Could this version of code not support DHCP on a interface? Thoughts? ~~~~~~~~~~~~~~~~~~~~~~~ SHO VER Cisco Internetwork Operating System...

I have a trunk port setup between a 2950 and a 4507. The connectivity between the two switches is very slow. Thoughts ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ ~ THIS IS THE INTERFACE ON THE 4507~~ interface FastEthernet6/12 switchport trunk encapsulation dot1q switchport trunk...

This is from the Router I was working with lasnight, that I had the IOS upgrade problem. ~ The router does not sho any of the interfaces. No f0/0 or f0/1 or s0/0. When you do the "sho int" it returns no output. when you do a "sho run" none of the interfaces are listed. Thoughts- suggestions...

CODE UPGRADE GONE WRONG --- I TFTP an image file to my 2600 router. When it finished, I did the reload command without resetting the boot system. I get this output now when the router boots up. it will only boot to "rommon". ~~ Thoughts other than "kill myself" [yinyang] ~~~~~~~~~~~~~~ tcp...

I am connected to the internet via cable modem. I have a linksys broadband router\gateway (acting as a gateway) between me and the cable modem. I also have a Cisco 2600 Router with a Cisco 2950 switch behind the Cisco 2600 router. The router has a static assigned address for the e0/0 interface...