Search results for query: *

When I left click on the 'Safely Remove Hardware' icon on my taskbar and select safely remove hardware, after a few seconds I am getting the following error: |-RUNDLL-----------------------------------------| |An Exception occurred while trying to | |run "shell32.dll,Control_RunDLL...

I'm pretty new to the Octel system. How do you set it up to where you can administer the Octel switch via a dial up connection?? Can you use Hyperterminal?? What settings do you have to set Hyperterminal to (8-N-1 or ?-?-?, 57600 or ???. etc)??

I have a Benchmark DLTtape DLT1/VS80 tape drive that I would like to enable Compression on. How would I do this?? Also, I would like to check to see what version of Firmware is on this drive and update it if it needs to be. I've looked at the manaul on how to do this, but I can't understand how...

I've seen the following in other posts and would like to know Detailed instructions on how to do this: Verify your TTY is set up to match the same baud rate as your modem and you should be good to go. How do you do this on the Meridian 11c switch?? What card are you connecting to because you...

I need to know what ALL commands to execute at the terminal hooked up to an Meridian 11c to print out all of the settings so I will know the following: baud rate to set the modem to 8/N/1 or 7/E/1 Flow Control On or Off Error Control On or Off etc, etc, etc I'm new to the Meridian switch, so...