Search results for query: *

Gentlemen, Has anyone had success setting up J179 remote phones utilizing an Ingate SBC? I can successfully register the phone and make calls, but no programmed buttons (other than 3 call appearances) appear and buttons such as the voicemail button don't work. This is a Server Edition Release...

I have been doing some testing with an IVR and have ran into an issue with Release 9.0. It appears when using SIP endpoints, Avaya is no longer allowing REFER and when using SIP trunks they are preventing a blind transfer. I've ran monitor and wireshark to verifying what I'm seeing. Has...

Just in case anyone hasn't seen. The Release 9.0 Matrix has finally been released! cp

I'm looking for a 3rd party device to use for OPX circuits (Off premise extensions, I think it's also referred to as an 0213C circuit) between 4 IP Offices. My customer is in a very rural area and I'm still in shock that there is no way to do an SCN, but it appears we will have to reuse their...

I'm trying to get a SIP Rightfax server to dial out through the IP Office. I saw a previous thread where kwing112000 said he got this to work. Does anyone have any suggestions?

Hello! I'm sure many of you know that a 4424LD+ is not officially supported on the IP Office. The 4424LD+ will work with IP Office software 3.2 and below, but if you upgrade the software to 4.0 or above it will place the switch in a constant reboot cycle. If you unplug all 4424LD+ phones and...

Hello, Quick question. Can Voicemail Pro distinguish between a transferred call and a call incoming via a DID number? (With both resulting at the leave mail for the user) If it can, is there a way to set a test condition for this? Thanks, cpate

Hello! I need some assistance with voicemail pro. I have a customer who is wanting calls to route like this. Call comes in, if user isn't at desk (from 8-5) then call goes to Main Huntgroup. If it's an internal call they want the call to go to voicemail. If it's outside of the hours of 8-5...

I have a quick question. Let me preface this by saying, I'm just getting started (really really just getting started) to learn cisco. I've read posts and followed the advice to start setting up a lab. I've ebayed a couple of 2507 routers. They are supposed to have 16 Megs of DRAM and 16 Megs...