Search results for query: *

I am trying to add some 7020 phones to some unused ports on a D1232 with. I only get dead air on the hand sets, you can dial numbers, but no other buttons work. I have checked the wiring and everything looks ok..I have both pairs hooked up and polarity correct. Any ideas on what I am missing?

Is there a way to set a reminder for a call on hold. I don't want a parking lot timeout, Just some sort of reminder. I am using 1140e's Thanks!

Is there any way have a line (SLA) appear on a phone, similar to "appear only" on the Norstar? Want it flash but not ring and be able to press the button to answer. A bonus would to be able to see caller ID before answering ;o

Is there a way to break a conference call or disconnect / hold one party ?

Company with MICS and Callpilot 100 just moved to a new location. Would like to set up a greeting that answers immediately to announce the move before the call goes to the office. Currently using ccr tree set up with extensive menus set to answer after 5 rings. Is there any way to have an...

Has anyone experienced echoing on outside calls with an ASM? I have an ASM where the first 30 seconds of any outside call has a real bad echo of your own voice on the system side. After that it seems to go away. Problem is on all 8 ports of ASM. All lines are regular analog PSTN. No problem...

Is it possible to have have one group of extensions use one line pool for all calls and another group use a different pool and have everyone use the same access code, Ie 9, with the prime line as I/C? MICS 7.0 all copper.

I have noticed that the CICS will continue to ring a few times after the 90v ring signal has stopped on an analog line. I have a some analog phones hooked up outside the system (for caller ID purposes) and if a call is answered on them the CICS will continue to ring about 1-3 full times. This...

I've never been able to figure this one out. Have a night ringing service which sends calls to AA.(simple, right?) Would like a delay so Caller ID info can be recieved before AA answers. With the VM port assigned under a ringing service it will answer immedately. Cannot use forward no answer...

The call pilot is set up to park and page extension 25 under path 3 in CCR. When in a subscriber mailbox if you press 6 for park & page, it will announce "(name) 101." However, when going through CCR go direct to park & page it simply announces "101", even though it is assigned to an extension...