Search results for query: *

Is there a remote factory default command for UNISTIM Phones? I can factory default a UNISTIM or SIP phone using the **73639[MAC]## on the phone, and I can remote factory default a SIP phone by doing a SSH/PDT session with the phone and typing "reset2factory", etc, but I can't seem to do the...

I have a question on the Directory key for my 1230 SIP phone. I have a CS1000e release 7.5 with SIP phones on release 4. In my 1230DeviceConfig.dat file, I have my ADDR_BOOK_MODE set to NETWORK, and in my MAC file for this 1230 phone I define my address book file as 4010ADDR.txt. I am able to...

I have a question on the Directory key for my 1230 SIP phone. I have a CS1000e release 7.5 with SIP phones on release 4. In my 1230DeviceConfig.dat file, I have my ADDR_BOOK_MODE set to NETWORK, and in my MAC file for this 1230 phone I define my address book file as 4010ADDR.txt. I am able to...

Has anyone implemented SIP or Unistim IP Phones on IPv6? We are thinking of implementing IPv6 here, and I'm just wondering how much more of an effort it is to configure it, especially when we plan to install an Avaya voicemail system. I do know that the Avaya voicemail system uses the Avaya...

I have a CS1000E with beta 7.5 software. I built a SIP phone on a 1220 telset and I was able to login and make and receive calls. When I tried to add an appearance of another DN to my phone (doesn't belong to anybody else), I cannot login the new number and get a 404 not found message. Is it...

I have a strange problem when I dial from a CS1000E to a CS1000M over a T1 Tie route. Both PBXs are programmed as D4/AMI TRK (no dch) and DSEL is 3VCE. I have no problems dialing from the CS1000M on a DDP card, but when I call from the CS1000E it calls a different DN. LD 80 trace at CS1000E...

I administer a 4 node Meridian Mail release 13 system. The MMP40 HEX display for Nodes 1, 3, and 4 shows a normal "A" display, but Node 2 is showing an "E". I cannot find anywhere in the Nortel documents what "E" stands for, other than the fact that Nortel provides codes from 0 thru 9, and A...

Can I use one PC equipped with two NICs to manage my two PBXs? Right now I need to disconnect the ELAN connection on the first NIC for "PBX A" in order to use the Element Manager for "PBX B" on the second NIC (and vice versa). I tried disabling the NIC connection in "Network Connection" rather...

We are setting up 2 Norstars MICS 7.1 with Centralized voicemail (Callpilot). Each switch has their own copper PSTN trunks and are tied together with PRI-SL1/MCDN. Switch A (w/Callpilot) will have DNs 2XX and 3XX while Switch B will have DNs 4XX and 5XX. I was told that all I would need to do...

Is this scenario possible: The Opt 11C/Release 25.30 site I maintain needs to have the SSC replaced, according to tech support. I want to archive the database to a PCMCIA card and restore it to my lab switch by installing 25.30 software to the lab's SSC card, and use the same AUX ID/keycodes...