Search results for query: *

I hope this post will not go answered too. I have finally setup IPSec tunnel for vpn clients. My problems is that they get disconnected from the LAN and can't access the internet or any local site. I have read many post that I need to enable split-tunneling. I have created the following two...

I am getting the following error. Please any help. I have no idea what to do. I have edited the registry to disable to defualt ipsec plicy with MS. Tried with Cisco VPN client. I really don't know where to go from here. Please any .... any help. ISAKMP: phase 2 packet is a duplicate of a...

I am trying to configure PPTP on my Cisco PIX and cant seem to figure out what is wrong. I have wiped out the whole configuration and used the PDM to setup a initial site-to-site vpn and vpdn group. But I get the following error over and over. I have turned on debug on vpdn and I get the...

I want to setup the cisco pix as a vpn server for Cisco vpn clients to connect. I don't want to install the Cisco Secure Access Control Server (CSACS). How can I configure the pix to authenticate and manage the vpn users? Is this possible?

I have configured for Remote clients to connect via Cisco VPN Client with a pre-shared key. But my clients can't connect. I suspect the outside access list is wrong. But I did not create this entry and before I edit it, I want to know if this configuration is correct and how can I let access...

Hi, Can somome explin to me about these routes outside 0.0.0.0 0.0.0.0 888.888.888.73 1 OTHER static outside 888.888.888.72 255.255.255.248 888.888.888.77 1 CONNECT static inside 172.20.0.0 255.255.0.0 172.20.2.3 1 CONNECT static All I did was to asing a ouside IP address 888.888.888.77...

I want to disable dhcp for the inside network and point the interface to my existing dhcp server.

I have done the basic configurations to get my pix up and running. I have configured the basic stuff, host, domain, interface ip's etc. How can I setup a basic vpn server? Can I use the term basic here or is it going to make me suffer :-). Any basic setup or documentation how to achieve this...

I am new to PIX and excuse me if I make some dumb assumptions. I want to implement failover to my PIX setup. I know failover works with two and exactly two, firewalls witht the same model. I also read that PIX 501, 506 and 506E does not support failover. Now I have a PIX 506E and a cisco...

I am a recent CCNA and I going to be given the tast to confire a PIX 506E firewall. How can I prepare for this. What are the best reading materials out there? My requirement will be to setup NAT, VPN Setup and also allow access to WEB and FTP Services. Any help or advise would be appreciated