Search results for query: *

Hello, In LD 20, when you do an IDC, based on the ouput, how do you tell the card type? For example, NT8C02GB, the 02 indicate that it is a digital line card. What digits tell you if it is an PRI, ITG or Analog card? Thanks.

Hello, is it possible to re-load the default setting on a M7324 set? I am using a PRI and it is taking line 160 and i would like to give it something else since there is another set with that line. I am also confused as to why there are two sets with the same line number. Thanks.

Just wondering if you can change the target line assigned to a phone? If so, kindly post instructions. Thanks.

Hello, I am wondering how i can check the incoming digits on a PRI - similar to turning on MSGI on the DCH on Meridian switches. Thanks.

Hello. The switch i am enquirng about is an Options 11 4.5 software. On the 3904 sets, I set up the option to log calls and i do get the logs. On the I2004's i dont get the logs even though the loggin option is turned on. Do i need a different package or am i missing something in the switch...

Hello, I have an Option 11 that was powered down on the weekend. ON power up - everything came back except the analog card. In LD 32, i disabled the card then enabled. The TN's are programmed but there is no DT on the TN's. How can i check if the card is bad? Thanks.

Anyone tried the Xten softphone to see if it works. Apparently they (Xten - renamed CounterPath)have this on the roadmap for testing for compliance with Nortel. I want to try it anyway and would appreciate feedback from anyone who tried or planning to try it. Thanks.

Hello again. Just wondering if there is screen in BCM that shows the buttons assignment for phones and allow you to modify the buttons?

Hello, I have a BCM 400 with i2004 telephones. Some users want more buttons so i have to change the sets to T7316's. How do i go about changing the configuration? Thanks.

I am running Succession 3.0 on an Option 11. There is a remote site with a PoE switch and I need to add an analog device there. Is it possible to add an ATA on the Etherenet switch port? If i can, are there any special configuration?

Will these conference phones work with Succession 3.0 If so, are there limitations or known problems? Thanks.

Is it possible to establish 100MB full duplex on these cards?

Hello, Could someone direct me to a URL where i can find a worksheet for KEM's. I need this for users to fill out the DN's that they want to appear on their phones. I would also appreciate a template for the main display on the i2004. thanks much.

Hello All. On an Option 61, if you do a CDR buffer reset, does it dump all the records in buffer?

Hello. If you are upgrading an Option 11 to succession 3, is there a minimum or inherent software release upgrade? thanks.

Season Greetings. I have a phantom number range that is not contiguous. How can I add-in the numbers that are missing? i'd appreciate actual code instructions. Thanks much.

Hello, I setup a phone that will forward calls to the voice mail port when there is no answer. However, call go to the general mailbox, not to the users mailbox. What else do i need to do do so that calls go to the user's mailbox? Thanks.

Can someone post exact code to add/change the CLID in LD 17? Thanks.

I have a console that goes into night mode all by itself. One minute it is active and the next second it is in night without touching a button. Anyone seen this problem before and can you suggest what cold be wrong? thanks.

hello. I have two number ranges on an option 11. Examples: 362-xxxx to 362-yyyy 384-aaaa to 384-bbbb Outgoing call display for numbers in the 384 range are going out with the DN however it is using the 362 prefix. Can someone post a print out of how to setup 384 as well how to allow the...