Search results for query: *

I am currently trying to connect my Castelle Faxpress 5000 to my callmanager 6.1. I have read through the documents from castelle which really do not go into depth. Currently i am connecting it to a vg224 (setup as sccp in callmanager) and wanted to see if any knows what the fxs port settings...

I wanted to check and see if and would know the answer to a problem i am having. I am using cm6.1.2 with 1760 as a h323 gateway. I am connecting to comcast digital voice service to my fxo card. I am finding that i can only get 1 out of 3 calls in from the outside (FXO card LED only lites on...

I have a callmanager 4.1 and had a network down issue this week. Since this time the 7936 conf phones have not registerd back to callmanager. Currently they are stuck on configuring ip address. I have checked the DHCP server for the mac addresses of the phones and clear out any leases that...

I running a cme 4.1 and have a question about trunk groups. I am using four pots lines in a 4-fxo and assigned them to a trunk group. I have the outbound dial-peers setup with the trunk group command. If i disconnect the first pots line from fxo-0 and try to place a call I get a busy signal...

I am looking to see if anyone has installed cm 6.0 on a generic pc. I am looking to install it to test it in a lab enviroment. I have done it in the past with version 4. Any help would be great. Thanks!!!

I have job of setting up a cisco 4400 wireless controller on our network. The network consist of cisco 3750 gig switches performing the layer 3 routing. I have a dl320 as the DC giving out dns and dhcp for two networks( w/dns entry for controller). the data network is x.x.10.0 and the wireless...

I am new to administrating changes in callmanger 4.1 and have recently given a new block of DID's to change all my users to. The old block was xxx.xxx.5000 numbers and the new block is in the 7000 range. I tried to line up the DN's to have the last two digits the same but not all line up. How...

I have a client who needs to have a strobe light and external bell ring to notify warehouse workers they have a call. I have seen this done through an cisco ata before i believe and just wanted to get some feedback if their is a better way of doing this and if their is a specific way i should...