Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Selecting media for backup job
When you set up the job, check the "eject media after job completes" checkbox on the device and media page of the job setup... hope this helps, --matt- Tesch
- Post #5
- Forum: Data Recovery general discussion
-
Re-inserting tape magazine takes library offline
I had a similar problem, and finally found a workaround that didn't require me to restart--this may work for you, too. For each device that is offline, right click on it, and go to properties. on the "configuration" tab, uncheck "Enable device for Backup Exec". Clcik Apply and close the...- Tesch
- Post #2
- Forum: Data Recovery general discussion
-
WIC-1ENET card not registering on 1720
I have a CISCO 1720 router with a WIC-1DSU/T1 and a WIC-1ENET installed in the slots. I have tried each individually in each slot, and I have tried both cards in the router, and switched their position here as well. In all possible cases, The T1 card seems to be working--I can plug a T1 line... -
1710 with VPN and NAT
I am trying to create a VPN tunnel from one private network to the other. I do have to use NAT to do this, right? -
1710 with VPN and NAT
I am working with a CISCO 1710, trying to connect it through a VPN to a 1720 across the internet. However, the NAT doesn't seem to be working right. When i do a traceroute, the message dies as soon as it gets out of my router, because it's a private address (for my network, and the one i'm...
