Search results for query: *

Hi all, I have a problem configuring trunk on 2908-XL. Could you tell how to enable trunk, configure encapsulation? I do not see the commands to specify this parametres. May be I have to change IOS, currently it's used Version 11.2(8.2)SA6. Thanks, Mike

Hi all, I've got a problem in configuration of VoiceGW (Cisco 1750) and RADIUS. Situation: I configured Cisco for start-stop accounting and trying to make a call from one phone to another. Cisco sends me a lot of unnecessary and confusing information. It makes a record when I pick up a...

Hi all, I've got a problem in configuration of VoiceGW (Cisco 1750) and RADIUS. Situation: I configured Cisco for start-stop accounting and trying to make a call from one phone to another. Cisco sends me a lot of unnecessary and confusing information. It makes a record when I pick up a...

Hi all, I have a problem with interconnection of two Cisco routers (2600 and 1750) using FastEthernet interfaces. When I am configuring them with "speed 10" all works fine with both half and full duplex. I can ping a router through this connection. But if I make "speed 100&quot...

Hi all, I have to choose the proper IOS to 26-series router to function as a gatekeeper. I can not find out which IOS supports that feature. How can I find out that? Thanks, Mike

Hi all, I've got a problem understanding AS5300 operation as a voice gateway. How many simultaneous voice calls it can handle? We have a chassis, quad E1/PRI card, and AS53-VOXD VoIP card. The manual says that AS5300 can have only 1 VoIP card installed which contauns 5 DSP module sockets (5...

Hi all, I'd like to ask those people who have already passed new version of CCNA certification with their innovations (interactive router prompt, etc.). I'm really anxious about new CCNA cert because I've never tried it (I used only Boson without such features). Are there a lot of questions of...

Hi all, I was asked to clarify an "ip transit" term for my bosses and a ways it can be provided. I've managed to find only MPLS-based structure for "ip transit". Are there any other ways to build "ip transit" (tunnels, ATM, etc.)??? Please give me links on resources...

Can someone please explain me why Ethernet's "Link" LED comes immediately up when connecting to other Ethernet device? Is there some constant voltage on TX+ TX- pins or it's a result of layer 2 protocol action or something else? Thanks, Mike

I think your physical layer was configured so it could make problems for some data patterns. I'm quite sure you had problems with long patterns (2^20, QRSS, etc) and it was all right with short patterns. Inside these long patterns there are intervals with exessive numbers of zeros. In some cases...

Hi! There is a problem and I know it's possible to solve it but don't know how. Situation: There is a remote router#1 which I can access through telnet. In the close proximity of this router#1 there is another router#2 which I have to configure but I do have neither ethernet nor serial...

Hi, I've got a little problem. I'm asked to organize 640kbps(=10ts) serial connection between 2 back-to-back connected routers. But I can not specify 640000 with "clock rate" command, only 500000 or 800000. Are there any ways to solve the task or it's impossile provide 640000 serial...

Hi! How can I determine is my router works as DTE or DCE on serial connection. It depends on cable or configuration? Can I use "clockrate" command only for DCE? Any useful tips? Thanks in advance.