Thanks a million travs69
I have actually looked it up, and found
[Timeout => $secs,]);
Now how do I incorporate this in my script was teh problem, I am less then a beginner....but definitely not taking short cuts to get a quick fix.
so please, if u are here to help people like myself dont...
Thanks for the replies !
I am a total newby, and only managed this script by patching here and there and testing....
can u tell me how to extend the timers ??
Hi all
I have started toying with net::telnet, this is my butchered script for ISO upgrades, but it times out leave me with partial images.
can anyone advise wjhat I am missing ?
TIA Sam
use Net::Telnet::Cisco;
$username = "sam";
$password = "cisco";
$enable = "cisco";
my $IP = '10.1.1.1'...
Hey there
I used it, it was all in all good and allowed me to configure few things I was not too sure about. The routing side did not have much BGP ( I was hoping for complex scenarios ).
The switching part has to be the best. Remote access was not bad either. so yes, overall it was a good...
HI all
Just done a huge 360 degree turn and changed career, I am CCNA and work for an ISP.
Can u recommand any books /sites, where I can get the necessary knowledge ( routing troubleshooting, latency, leased lines and ISDN's problems ) not too much theroy but practical stuff..... am I asking...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.