Search results for query: *

Thanks everyone, I got it to work with your help.

I am trying to enter in a static mapping. I enter config mode and have tried a number of commands. write terminal (inside,outside) x.x.x.x 192.168.10.22 netmask 255.255.255.255 0 0 write memory (inside,outside) x.x.x.x 192.168.10.22 netmask 255.255.255.255 0 0 It builds the configuration and...

I have installed a GBIC card into a switch. I have then connected the card to a fiber connection that is going to connect two buildings. When I go to Cisco Cluster Manager the card I just put in doesnt show up. What do I need to do to get it configured. I just want it to be recognized. The...

For the time being we will actually not need to access any of the machines on VLAN2. So maybe If I change the switch IP address in the 30.x range to 10.x range. Then I could create a vlan that supports the 30.x range. This should work ok right. My plan is to set their firewall and router all...

I belive it is the virus case. They are set to scan ranges of IP addresses. You just happen to be getting hit with some of the traffic because you are on the same network.

We are going to be connecting two separate buildings through a fiber connection between the two buildings. Right now each building has its own T1 connection, firewall etc. We want to be able to connect the buildings so that we can setup a couple of machines that are going to connect to our...