Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. scotsguy

    What is Interface Reset?

    take it you have checked Autonegotiation and in particular Duplex and Speed parameters on both ends ?, if not try setting to half-duplex then watch counters (having cleared first) then ramp up etc J
  2. scotsguy

    Throttles

    we have ip helper address stmts against those Vlans requiring it on catalyst before it will work, this doesnt stop the requests, only allows them thru !
  3. scotsguy

    XYPLEX to CISCO

    not sure what the problem is but I had issues connecting to XPLEX using PPP and on Cisco I had to enter a command IPCP ACCEPT ADDRESS b4 I could get them to talk - best of luck with it. J
  4. scotsguy

    Problem with RIP

    think you should be configuring the isdn's as 'backup interfaces' to the serials, this should cause them to drop after the dialer idle timeout is reached, an alternative is to use floating statics with a metric of say 200 (assuming you're using default metrics)
  5. scotsguy

    IP Helper and Bridged VLANs

    not sure if we have same setup but the ip helper address go under the int vlanN part of config and can be set to a variety of addresses
  6. scotsguy

    Nat problem or is it routing confusion?

    when D1 is active what does the command show ip route 10.132.129.0 display ?

Part and Inventory Search

Back
Top