Search results for query: *

You will also have to move you Security Device (Dongle) to the new SSC card. Wayne

The default data settings for port 0 on the NTBK48 cable are 8-N-1 and can't be changed. The only thing that can be changed is the baud rate on the face of the SSC. Make sure you don't have 2 switches set on the baud rate switches. I've seen that cause communications problems like you are...

If it is an Option 11C Cabinet or Chassis system upgraded to a CS1000E, Cabinet 0 becomes Loop 0 Shelf 0, Cabinet 1 is Loop 0 Shelf 1, Cabinet 2 is Loop 4 Shelf 0, Cabinet 3 is Loop 4 Shelf 1 and Cabinet 4 is Loop 8 shelf 0. If it is a CS1000S upgraded to CS1000E it starts with MG 1 being Loop...

The NTP does not give a distance limitation. It says that the round trip delay must be less than 30 msec and packet loss must be below .1 %. All the requirements and limitations are found in the System Redundancy Fundamentals NTP NN43001-507 in the Campus Redundancy section. Wayne

Do you have just one cabinet? Since the card in slot 0 is an NTDK25 Fiber Receiver card it is an Option 11C expansion cabinet. If there is a fiber cable connected to the fiber receiver card the other end of the cable will be connected to the Main cabinet. If it is a plastic fiber cable the Main...