turn off call fwd no answer in set capabilities
for that dn
program aux ringer in service modes
use dry contact yel/grn pr on station cable to activate
contacts on amp if you have one or you will need ring unit
wired to page input of amp
some amps have some dont but there are lots of external...
i have worked on mitel pbx with key systems
co,s connectted to pbx station ports
key system can dial 9 etc.
but wont recieve call id info unless pbx supports
pretend your pbx is your co
no power supply needed
1st 6 pairs of 25 pr cable are for bridging the 6 lines
use t connectors or a bix 2a block for duplicating co lines
co line to dup then one to ksu and one to CII
hook any station port to screw terminals were you
wanted to hook power supply to
unit will still need...
does flash 2 2.0 need dr5 11.07 like flash 2 3.0 or can it
run on any dr5 software level on a 8 x 24 modular ksu
also can you tell the level from part numbers of the dr5
cartridge as i dont have 8 x 24 ksu handy to check the
3 i have
thanks for your help
woodywill 01 17 2002
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.