Search results for query: *

Is it possible to get a branch office/lan to lan VPN to work between a Cisco PIX firewall and a Watchguard X-Peak? I have searched the posts and found one that mentioned this, but what I read did not work for me. Does anyone know if this can be done? Thanks in advance.

I have a VPN that works great from many PIX 50x back to a Cisco VPN concentrator. Now, the powers that be, want to push all traffic across the VPN tunnel so web traffic can be monitored from a corporate server. Is this possible?

Does anyone have a config for a Cisco 837 router with Verizon Static DSL. I keep getting the run around from them. I am pretty sure the config I have is correct, I just want to see a working config to verify. Thanks

Is there a way to restore the priv1.edb file and nothing else to a different location from Arcserve Brightstor software. I( do have the Exchange agent loaded and the backups work great. I can restore to the default location. I want to resore priv1.edb and use Recovery Manager from Quest Software...

I want to set up a LAN to LAN VPN from a Cisco 1841 to a Cisco VPN concentrator. I will use a Serial Interface on the router to connect to the Internet. I want all traffic to go to the VPN Concentrator and I want the remote site where the 1841 sits to keep theie same addresses when connecting to...

I did use the correct address in the static statements. You are cooorect that 10.0.0.2 is not correct. I had to change the addresses to protect the company. Let's say that 10.0.0.2 is used for all NAT/PAT on the network (general web traffic). I want both servers to appear as 10.0.0.3

OK, that did not work. Once those lines were added both servers showed up as the NAT address for everyone on the internal network.

The address that is being used is a PAT address for all internal PC's/Servers. Does this matter?

Below is the message I get because the email server is getting NAT/PAT'ed to a different address than what is used when email enters the firewall. I want both internal addresses NAT/PAT'ed to the same external address as if they were one server. Email going out does not pass through the filter...

OK, I must be dense or something. I have posted part of the config below. IP addresses have been changed. All traffic on port 25 is coming into the email-filter server. The external IP for the filter server is 10.0.0.3. I have an email server on the internal network that I want all traffic...

I guss this needs explaining. The Ip address I ant to use is being used for an email filter server for inbound traffic. I want the mail server to use the same address for outbound traffic. Is this possible?

I have one server that I would like all traffic leaving the network natted to while all other servers and hosts use another address. Is this possible?

I have a mail server on the inside of the PIX that I want translated to a certain outside IP address. The outside IP address that I want to use is currently being used by the email filter server. Is there a way for both servers to use the outside IP while the remaining network gets natted to...

I currently have an Windows 2000 serever running Exchange 2000. Exchange runs great. The problem ius with Brightstor 9.0. I also have the Brightstor Exchange agent installed. The problem is that I get tons of W3404 warnings saying "Unable to open file." Anyone know how to fix this?