Search results for query: *

I am at my wits end with this one. I added a slideshow picture gallery to my web page. The picture gallery seems to set it's own minimum size. I can make the picture gallery larger but can't get it any smaller. I have tried everything from tyring to drag the edge of the table to resizing the...

Any experience with how well Netscreens and PIXs work together?

is it just me, or is he missing the route statement as well?

We have only PIX 515 and 525 firewalls in the core of our network. Because of the 3Mbps limitation of IPSEC throughput on the PIX 501 we are thinking of implementing Firebox firewalls/VPN devices at our small remote sites (1-2 users) instead. Does anyone have any experience with getting these...

I have a L2L tunnel built between 2 PIX firewalls. Occasionally the tunnel will no longer assocaiate if site B tries to contact site A, only if site A tries to contact site B. Moral of the story, occasionally site A is the only side of the tunnel that can bring it up. I've tried different...

thanks for the info... would you know the command that i can reference in order to configure the b channel selection?

I have a 3725 that I need to configure to talk to a PRI and my callmanager. I have the callmanager up and now it's time to configure the router so it's ready when the phone company turns up the circuit. I am not sure how to answer the following questions from my phone company or where to go to...

thanks, i knew about the show who, i just couldn't figure out the kill part...

How do you disconnect another admin session on a PIX? (ie. i am telnet'd in and want to disconnect another telnet session). Thanks in advance.

and i am assuming that the 'switchport mode trunk' command has to be entered for each interface? i didn't include that in the config in my previous post

So will this work? interface GigabitEthernet0/2 no ip address channel-group 1 mode on ! interface GigabitEthernet0/3 no ip address channel-group 1 mode on ! interface GigabitEthernet0/4 no ip address channel-group 1 mode on

I have 2 3700 Series switches, each with 4 1Gbps SFP ports. I want to know if there is a way to bond these ports together to make a single 4Gbps uplink between the switches. If this is possible, how would I accomplish this? Thanks in advance.

what do you guys think of SolarWinds.net and their Orion Web-based series? I am thinking of purchasing it.

DOH... should have looked closer, it says RS-232 right on the port. I thought there was a way to feed individual phones an analog line as a backup though... is this true?

bump

I just received a shipment of 7940s, 7960s, and 7970s but the Callmanager and Unity servers have not yet come in. I would like to replace the current analog phones on the desks here with the Cisco phones and use the existing PBX via the analog port on the back of each phone. I have searched...

so it is best to use it in lan-to-lan configs? when you say it sends the config, what exactly do you mean? not my whole pix config right? what exactly is extended authentication? Thanks for all your help.

What does "no-xauth no-config-mode" actually do when added to the end of an ISAKMP line?

Here's my current sysopt config: I don't have the noproxyarp applied. no sysopt connection timewait sysopt connection tcpmss 1380 sysopt connection tcpmss minimum 0 no sysopt nodnsalias inbound no sysopt nodnsalias outbound no sysopt radius ignore-secret no sysopt uauth allow-http-cache no...

Some of my VPNs terminate to my DMZ interface and other terminate to my INSIDE interface. None of the interfaces shut down when this happens as regular internet traffic still passes. What does that sysopt command do and why would i want to apply it? Thanks!