Hello there,
I have a Cisco 827 router with NAT enabled. I have several PAT commands working fine. My ISP routes me a /29 network to the routers Dialer1 interface. My internal network uses 192.168.0/24. I have several of the following commands forwarding specific ports to several internal...
Hello again MrIPO,
The number ranges I need routing via the new VoIP Link are as follows:
At site A - Just the numbers 790-797 inclusive.
At Site B - 100-789 inclusive (with the exception of 500), 800-998 inclusive, any number starting with 118 and *604 (a short code to check a single voice...
Another couple of questions for MrIPO (sorry, forgot these).
I presume that your instructions create an IP data link between the two sites using ISDN? This being the case I presume I need to create a new VoIP line at each end in order to route voice calls over this link? Should I use the...
Thanks a lot MrIPO,
I'm just following your instructions now. There is one point though, should the IP route destination at Site A actually be ACME (the same name as the service and user)? As the destination is on a drop-down list I can't enter a value that has not already been defined on...
I have an IP Office 406 (1.4(22)) with 3 x 30 POT modules (3.4(22)), 1 ETSI PRI and LAN connection at our central site. At a small remote office I have an IP Office 401 (1.3(34)) with 1 BRI (ETSI, BT Highway) and LAN connection.
At the moment the two are linked with a VoIP 'line' via ADSL...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.