Search results for query: *

I have promised to help a guy with a few design issues. First of all his employers are dialling-in to the company when they need a connection from home (they have 2 ISDN modems on the site). Second, they are all using public addresses on the LAN. Third, his got some employers he does not...

Before i changed anything, this router had a single-port WIC installed and was connected to a NT box running ISDN PRI. Everything working fine and still is. I simply switched the WIC with a dual-port WIC module and added another controller/serial and connected nr 2 port on the module to new NT...

ive configured cisco 2811 routers, each with a WIC installed. Router "A" has a multiport WIC installed (2 ports) and router "B" has a single port WIC installed. Both configurations are the same, except for the router with the dual-port WIC which have an extra controller and serial interface...

These 2 routers are connected with WIC cards and its possible to ping from one LAN to the other. The problem i see is that the connected serial interfaces are in different network: Router 1: 192.168.10.1 255.255.255.0 Router 2: 192.168.20.1 255.255.255.0...

okay, both s0 and s1 are down/down so i need another router and configure dce/dte i think im home safe now. :)

im a little confushed here. should i be able to ping a serial interface that is not connected wiht a cable/router in the other end? should i be able to see it in "sho ip route"? if not, then its probably working fine once i get the other router and i can go to bed, finally :)

i dont get it, did i do something wrong? i mean shouldnt i be able to ping serial 0 and 1 when pinging from a PC connected to Eth0 having the IP 192.100.200.l0 i can ping the lan interface (my gateway) but not my serial interfaces, something i missed? controller E1 0/0/0 channel-group 0...

i think i got it, thx alot guys. controller E1 0/0/0 channel-group 0 unframed

Asminderoed#sh run Building configuration... Current configuration : 1755 bytes ! version 12.4 service timestamps debug datetime msec service timestamps log datetime msec no service password-encryption ! hostname Asminderoed ! boot-start-marker boot-end-marker ! ! card type command needed for...

:) okay let me just get tera term first, will take 2min. thx for your time.

Current configuration : 1755 bytes ! version 12.4 service timestamps debug datetime msec service timestamps log datetime msec no service password-encryption ! hostname Asminderoed ! boot-start-marker boot-end-marker ! ! card type command needed for slot 0 logging buffered 51200 warnings ! no aaa...

Also, i get no respons on the command: Router#card ? (trying to set card type to "e") the command does not excist on the 2800 it seems.

i have no experince with this module so this might be something very simple. i tunred off the router and installed the module in HWIC1 and powered up the router. when i do a "show running" there is no serial interface, i had hope to see serial 0 and 1 ive read the post called "Multiflex trunk...