Search results for query: *

Sounds like it is perfect now! SOLVED with Vipergg's help! [FIGURE_B] DSL_Modem (192.168.0.1)--->Router_Main (192.168.42.1)--->Switch_1--->Switch_4--->Switch_3 To summarize: I have used the following methods to achieve a working topology (FIGURE_B) as diagrammed above: [1] I replaced...

Thanks again! Bink from the other forum gave me a heads up about port mismatch right around the same time that I noticed that my speeds dropped to 1/6 of my previous connection. I ran: clear config all set spantree portfast 2/1-48 enable set port host 2/1-48 and my speeds are as good as they...

SOLVED: SOLVED! [FIGURE_B] DSL_Modem (192.168.0.1)--->Router_Main (192.168.42.1)--->Switch_1--->Switch_4--->Switch_3 To summarize: I have used the following methods to achieve a working topology (FIGURE_B) as diagrammed above: [1] I replaced all cables between switches from...

I made a crucial mistake: I mistakenly made a straight-through cable instead of the crossover cable between Switch_1 & Switch_4

I apologize for being unclear: The problem seems to originate (please refer to FIGURE_B) between Switch_1 & Switch_4. Switch_4 (2948g) does indeed see Switch_3 when it is connected to it, but it does not see Switch_1 when it is connected directly to it. As switch one is on the way to my...

Hi vipergg! By following the advice of a very nice member of networking-forums.com I disabled STP ("set spantree portfast 2/1-48 enable"), but I am not sure if it did much (I will leave it off anyway). I also decided to go ahead and setup the network in this manner: <b>[FIGURE_B]</b> <b>...

I bought a 2948G switch from eBay few months back and have not been able to get it to work: e.g. getting it to work as a switch. I read through the 400 page manual and was able to reset it to factory defaults. I did not find any information on the configuration needed to provide "basic...