Search results for query: *

When I try to open a file using File/Open/Look in: drop down arrow. my system freezes. Can anyone help? .

Got it, but not really I realized that the L1 wireless card works in L2 and I can ping with the Cisco card. Now what should I be looking for in order to configure the linksys card to do the same?

Correction I can split tunnel with L1 & L2

I can browse the internet with L2 while connected to the tunnel, but cannot with L1 not sure is that matters. Also, L1 Node type is Hybrid and L2 is Peer-to-Peer. Here is route print from L2 while connected: Interface List 0x1 ........................... MS TCP Loopback interface 0x2 ...02 00...

What should I be looking for if it is a routing issue?

So what you are saying is while I am connected to the tunnel check my services to see if ICF was started, because it is not started right now, but has a startup type of Manual which means if a componenet is dependent on the services it will start. None of my network devices has this feature...

The connections are as follows: I can ping the server side with L1 not L2 HQ uses 192.168.1.0 HQ server uses 192.168.1.75 Linksys VPN router uses a static IP from Verizon and a LAN gtwy ip of 192.168.1.1 Where my laptops are located does not matter as much because I have tried this setup from...

mhkwood you are right I can ping from L2; static ip assigned to the HQ router any address on the internet nothing on the local subnet (HQ) 192.168.1.0 L1 can ping everything While connected through vpn with L1 I run a tracert to 192.168.1.75 and it takes one hop to resolve. While connected...

I have two laptops: L1 running WinXP/Nortel Ipsec client/Sentinal Ipsec client L2 running WinXP/Sentinal Ipsec client L1 can connect to the tunnel and ping local ip addresses. L2 can connect to the tunnel but cannot ping the local ip address Tested both system in different locations same...

The tunnel was working now it is not and nothing changed I When I run the dianostics in ssh I get a message saying the remote end does not respond to IKE proposal phase 1. When I check the linky log it said the tunnel was created succesfully. What gives? I tunnel was not established so!

I have two Linksys BEFVP41's I created the tunnel (1) I can net use from the main office (192.168.1.0) to the remote office (192.168.2.0) I created tunnel (2) contacting SSH client (192.168.3.0) to the main office, I can net use to the main office. I can not net use to the remote office, does...