Search results for query: *

Problem solved... I disconnected a Cisco VoIP phone that was not configured (constantly "registering"), that was connected to the FE0 port. Now that the phone is out of hte mix I have been solid for 2-days now. My new challenge is to configure the VPN in the router for that phone but for now I...

Confirmed, I open the SDM and the system memory is half full or so but the 24k flash is almost maxed. Tried as you suggested, unplugged all network connections and then sent reload command. I don't know how to run logs using CLI so I came back 9 hours later, added one connection only and I was...

Yeah here's what I get when I try that command: yourname(config)#no ip time-out http ^ % Invalid input detected at '^' marker. Here is the show ver result: Cisco IOS Software, C870 Software (C870-ADVSECURITYK9-M), Version 12.4(15)T7, RE LEASE SOFTWARE (fc3) Technical...

Hi and thank you for helping. Unfortunately I am not sure what you are asking, I am very new to these things so I apologize I am slow. I am on ADSL here. Not sure what you mean by IP route or vtp domain. Can you send me the CLI commands to try? I sure appreciate it. I also tried the no ip...

Unfortunately, still having the same problem. After 8 hours I have to reboot the router because I lose DNS completely. I am sorry to be such a bother! I really appreciate your help. Here is my running config including all the changes from this thread, perhaps this will shed some light...

Hello again, I tried the ppp ipcp dns request ppp ipcp wins request but I still got disconnected. I just rebooted now, I added the pap authentication as well now. My ISP had told me to just use one but no harm found in adding the PAP as well. Yes when my router disconnects I can ping...

Hmm, well that Mac is a Nintendo Wii console I have connected to the Guest VLAN to download software updates. Interesting though that the Wii can get online no problem. Seems there is a bit of an authentication issue but now instead of the errors popping up every 15 seconds on the CLI it is...

Hmmm the router should be set for static IP, not DHCP. But it looks like both sets of commands are in there. Could that be the problem? interface Dialer0 ip address 76.10.188.115 255.255.255.0 ip access-group Internet-inbound-ACL in ip mtu 1452 ip inspect MYFW out ip nat outside ip...

Hi all, I am new to Cisco and the CLI in particular. I recently acquired the 877w router for home office use. I was hoping to try and get it running using SDM but it seems the CLI is still needed. Total newbie to this stuff...I've managed to cobble together a functioning config...however I have...