Search results for query: *

Thank you for your help again, below I have attached your config viconsul. I went through and edited the stuff that I knew about, and the config that I'm not up to speed on I marked questions out beside them. As of encryption and mac address filtering I would like to take all that out. This...

Ok great thank you that helps allot!! Ok now that I have that straight, if I took this config and edited the vlans to match my vlan set up, how could I take out the authentication out and the wep? So I can paste it into my AP config, I do not wish to have any athentication at this point. This...

So by looking at this config, it looks like you have the access point set up in trunk mode just like I have the switch correct? If I am then it is just like setting up a router on a stick with a switch it is just that we are extending out the switch to the access point for wireless devices to...

The switch Im useing is a older model it defaults to Encapsulation dot1q, I think the command I used was switch trunk mode. But really what I am asking if someone could give me a config file that was copied to notepad with the config for a Aironet 1232 access point. So I can go through and see...

I have another question on my access point, I set up a Unified Callmanager express on my 2611 router, I have it hooked to a 2950 and its programed like a router on a stick. I have my vlans set up with a vlan 10 for data and a vlan 15 for telephony. I have hooked my 7912 phone up and have dial...

Thank You for your help!!!!

Thank you for your help, I ended up figuring out my issue. I had to change my PC IP address to the 10.0.01 network to get it to connect to the AP. This worked and I have the IP of the AP changed to my network IP scheme and I'm connect to it just fine. Now I need to figure out how to get my...

Ok what is the command to my port come back up is it the same as a cisco switch? no shut?

Yes I did, I reconfigured the access point, i even entered the old config back. I did all of this and still can't get access to it unless Im hooked through the console port. My question is does the mode button put it in a state that you can't get access throught the fa port or wiresless.

I have a Cisco Aironet 1232 access point, I had to use the mode button to recovery a passord. Before I used the mode button I was able to connect to the access point other than I could not do anything because of the lack of password issue. Now I have the password reset I can not connect to the...

Hello all, I just signed up for training for Cisco, does anyone have any recommendations for sites that will help me, and I am required to make a Engineering Journal on the class and have been looking on the net for an example of one if anyone has a suggestion on that I would appreciate any help...