Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. amalik

    Installing or Starting SSH Server on SCO Enterprise

    check this out http://support.sco.com/rn_cgi/partneronline.cfg/php/enduser/std_adp.php?p_faqid=115262
  2. amalik

    Blank console

    3Com Fast Etherlink XL PCI 3C905-TX
  3. amalik

    Blank console

    I installed second nic in pci slot on the box running sco 5.0.5 and the after the reboot the console went blank. Seems a hardware conflict. How can I resolve this? output of hwconfig -hc before installation of card is as device address vec dma comment ====== =======...
  4. amalik

    can not ping to recently installed networki nterface

    In BIOS IRQ was set to N/A. I set it to AUTO for second nic slot and everything is ok Thanks everybody for all the help
  5. amalik

    eisa config disk

    I have clone running openserver 5.0.5 How is eisa config disk created. If I have to add second nic card do i need to run eisa config utility or do it from cmos. I have eisa bus and pci bridge. one nic already exists and that is on pci bus. I have to assign an irq to this second nic as when...
  6. amalik

    can not ping to recently installed networki nterface

    does this mean the slot is bad? I have not tried anything yet will do it on the weekend.
  7. amalik

    can not ping to recently installed networki nterface

    this is the only slot available. there is eisa bus, pci-eisa bridge. being pci it is plug and play.
  8. amalik

    can not ping to recently installed networki nterface

    which IRQ should I use and how to tell which IRQ can be used without deleting some other stuff. where to change IRQ? Is it in BIOS when system startup?
  9. amalik

    can not ping to recently installed networki nterface

    i ran the command and interrupt line for 3Com card is IRQ- 0. There is another card and is working fine and that has IRQ- 10
  10. amalik

    can not ping to recently installed networki nterface

    yes 5.0.5a is installed. swconfig output for the driver looks like this 3Com EtherLink XL PCI (3C900) 3C 5.0.5a installed
  11. amalik

    can not ping to recently installed networki nterface

    I can ping to the interface address but can not ping to any other machine even on the same subnet.
  12. amalik

    can not ping to recently installed networki nterface

    I installed 3Com Fast EtherLink XL PCI (3C905) on a box running SCO 5.0.5. During the boot I am getting the following error message WARNING: idistributed: cannot handle interrupts from PCI device (handler F00E6AA4, device 0/12/0) I was able to configure the card and hwconfig looks...
  13. amalik

    kernel panic with trap type 0x0000000D

    Hi I am running SCO Open Server network system. The system has paniced twice in last 10 hours with the following message. Unexpected trap in kernel mode panic: k_trap - kernel mode trap type is 0x0000000D what can caused this trap and how can we fix this Thanks

Part and Inventory Search

Back
Top