Search results for query: *

How do I show the incoming (calling) number on my 4424LD+ phones? We have a Merlin Magix (v4, CKE5) with 100D/CSU/DSU-U connected to our PRI. Outboud Caller ID works, as does DID to extensions. Right now, I just see the trunk label and (if I press More) the trunk number (Trk-###). Call logs...

We're up and running! I ended up putting just the lower 8 (active) B-Channels and associated lines in the B-Channel Group (1) and the same lines in the dial out Pool (891) --- but I am certain there is no harm to adding them all. When I called in to bring up the circuit, they showed the D and...

Thanks, TouchToneTommy. That would be similar to how I had things configured at the start tonight with all channels defined --- outbound could have failed with a channel number mismatch, but inbound should have worked based on the exmaple you site. I'm at a loss for now....I'll pick up on it...

Telecommboy, I removed channels 1 - 8 and added channels 16 - 23, then removed lines 825 - 832 and added 840 - 847. Finally, I removed 825 - 832 from poll 891 and added 840 - 847. After clearing errors and renumbering the boards, I got the same result. Merlinman, this is a new PRI and has not...

memphisribs, thank you so much for your assistance. I've worked with Cisco voice gateways and PRI's before --- it's amazing how little diagnostic information there is to go on with the Magix in comparison... I removed the inactive channels and lines. When I configured the Magix, I did not...

Hi, all. Hope you can help --- I am struggling with a Merlin Magix PRI. I have a 100 DCD module connected to our PRI (8 channels active for voice, no data channels) and have configured per what I've read in the forum but I cannot receive or place calls. Outbound gives fast busy and the error...